Before Installation; Selecting The Installation Location - Parkside PSA 25 B1 Guia De Inicio Rapido

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 37
Ensure that the hose does not re-
wind itself. Doing so may result
in damage.
Never block the hose end with
your fingers or other objects
during use.
Installation must be performed
by a professional.
Discontinue using the product if
the plastic parts are cracked or
deformed. Always replace dam-
aged parts with genuine spare
parts.

3 Before installation

Make sure that you do not damage any cables,
power lines and water pipes during installation.
Check the installation area with a cable detec-
tor before drilling.
Remove the product from the packaging.
Check that the delivery contents are complete
(see fig. A).
Check to see if the product or the individual
parts are visibly damaged. If this is the case,
do not use the product.
3.1 Selecting the installation
location
Choose a stable weight-bearing installation
location.
Be aware of the weight of the product including
the water in the hose (see chapter „Technical
data").
Choose an installation location where the full
180° swivel range of the hose box
used (see fig. B).
Measure the distance to the tap so that the
connection hose
11
slack (see fig. C).
can be
3
can be connected with
3.2 Selecting the installation
material
For installation on a concrete or brick wall, use
the accompanying screws
(see fig. G). These are only suitable for
8
concrete or brick walls.
You will need a screwdriver with a head width
of 13 mm to screw in the screws
included.
Use suitable screws and wall plugs for installation
on other materials or plaster thicker than 10 mm.
Ask a specialist retailer about wall plugs and
screws suitable for the respective wall structure.
4 Installation
Mark the drill holes at the specified height and
drill four holes (see fig. E).
Insert the wall plugs
Mount the wall bracket
The wall bracket
1
Ensure that the wall bracket
the direction of the arrow (the arrow must be
pointing upwards). For concrete walls and
brickwork, follow figure G.
Mount the hose box
(see fig. F). Hold the hose box
. Guide the hose box
2
until the axle holes line up. Secure the hose
1
and wall bracket with the split pin supplied
(see fig. D). The bend in the open end of the
split pin
ensures that the split pin
9
not reopen.
Connect the tap connector
fig. H). Turn the reducer
connector
in accordance with the size of
13
the tap's connecting thread.
Connect the hose piece
hose
to the tap connector (see fig. I). Please
11
note that it will click audibly.
Connect the spray nozzle
nector with the water stop
it will click audibly. Ensure that the spray nozzle
is closed (see fig. K).
7
The product is ready to use.
and wall plugs
10
. This is not
10
into the drilled holes.
8
using the screws
1
must be attached vertically.
is attached in
1
on the wall bracket
3
by the handle
3
into the wall bracket
3
does
9
to the tap (see
13
towards the tap
14
and the connection
12
to the hose con-
7
. Please note that
6
GB/IE
.
10
1
9
15

Publicidad

Tabla de contenido
loading

Tabla de contenido