Genuine Innovations G3517 Instrucciones Para La Reparación Y El Inflado página 4

Motorcyle Tire Repair Instructions
A. Inspect and remove the source of the puncture. NOTE: Some items may require the use of pliers or similar
tool to remove (See Image A).
B. Insert reaming tool into hole in tire. Using in/out motion clean out puncture to prepare for repair. Make
sure to remove all debris (See Image B).
C. Remove one of the repair plugs from the package and install it onto the plugger (See Image C).
D. Using the plugger, insert the plug into the puncture making sure to leave at least 1/2" remaining above
the tire (See Image D). Remove the plugger while carefully making sure that the plug stays completely
inside the puncture.
E. The plug will remain in place while the tire is ridden slowly and safely to a location to be repaired. It is
recommended to clip the plug down to approximately 1/4" from tire's outer most surface with wire cutters
or another sharp cutting device (See Image E).
Using the Monster Air Chuck: Inflate tire to recommended pressure and check to see if the repair is
holding by applying soapy water solution to the puncture area. Check puncture area and tire pressure
periodically to ensure that the repair is holding.
A
WARNING: It is not recommended that sidewall punctures be repaired. Plugged repairs
should not be considered permanent. Get tire professionally repaired or replace as soon as
possible. Ride slowly after repair is made until professional repair can be performed as a
blowout at high speed can result in injury or death.
ITW Global Tire Repair
125 Venture Drive, Suite 210, San Luis Obispo, CA 93401 USA
www.genuineinnovations.com • comments@genuineinnovations.com
See website for details on warranty • Made in Taiwan
B C
D
E