To get the best from your air conditioner, follow these
recommendations:
•
close the windows and doors in the room to be air
conditioned.
The only exception is when the appliance is installed
through a hole in the wall.
In this case, you are recommended to leave a slight
draught through a door or window to guarantee correct
ventilation.
•
Protect the room from direct exposure to the sun by
partially closing curtains and/or blinds to make the
appliance much more economical to run;
•
Never rest objects of any kind on the air conditioner;
•
Never obstruct the air intake or outlet grilles 1-6-8.
•
Make sure there are no heat sources in the room.
•
Never use the appliance in very damp rooms (laundries for
example).
•
Never use the appliance outdoors.
•
Make sure the air conditioner is on a level floor.
Before cleaning or maintenance, turn the appliance
off by pressing the ON/OFF button (A) or in models with
remote control unit, by pressing the ON/OFF button 19,
then always unplug the appliance from the electrical
receptacle.
CLEANING THE CABINET
You should clean the appliance with a slightly damp cloth then
dry with a dry cloth.
For safety reasons, never wash the air conditioner with water.
Precautions
Never use petrol, alcohol or solvents to clean the appliance.
Never spray insecticide liquids or similar.
CLEANING THE AIR FILTER
To keep your air conditioner working efficiently, you should
clean the dust filter every week of operation.
The filter is housed in the intake grille.
To clean the filter, remove the filter as shown in figure L.
Use a vacuum cleaner to remove the dust collected on the
close doors and
filter.
windows
If it is very dirty, immerse in warm water and rinse a number
of times. The water should never be hotter than 104°F ( 40°C).
After washing, leave the filter to dry. Put the filter back in its
housing.
START OF SEASON CHECKS
Make sure the power cable and plug are undamaged and
the ground connection is efficient. Follow the installation
do not cover
instructions precisely.
the appliance
END OF SEASON OPERATIONS
To drain all water from the circuit, remove the external cap by
unscrewing it in the anticlockwise direction then, remove the
internal cap from the drain hose on the back of the appliance
and allow the water to drain out into a basin (figure M). When
the appliance is empty, replace the caps.
Clean the filter and dry thoroughly before putting back.
close blinds or
curtains
L
10
Tips/ Cleaning
en
M