Foppapedretti JUMBO Manual De Instrucciones página 23

• ENGLISH •
ASSEMBLY - USE
UNFOLD THE STROLLER
CAUTION: make sure that the child, and any other children, are at a safe distance away when carrying
out this step.
The moving parts of the stroller must not for any reason come into contact with the child's body.
Move the closing lever "a", as shown in the figure (fig.1).
Lift the handlebar until the chassis opens completely. A click will indicate that is has been fastened (fig.2).
Before using the stroller, make sure it is opened properly and the mechanisms are properly locked.
INSTALL FRONT WHEELS
Fitting the front wheels (fig. 3): A click will indicate that it is inserted correctly.
Check that both the wheels have been fastened correctly, if they are pulled downwards they should not
be released.
Move lever "a" downward to block the swivel movement, and upward to activate the swivel movement
(fig. 4).
Removing the front wheels (fig.5): Press the steel button "b" front wheel released.
REAR WHEELS
Insert the wheel pin in the hole, a click will indicate it has been fastened in place. Make sure that the
wheel has been secured correctly, it should not come away when it is pulled outwards.
Removing the rear wheels (fig. 7): Press the metal lever "a" on the wheel hub and, at the same time,
remove the wheel.
ASSEMBLING THE HOOD
(fig. 9)
Assembly: Insert the front arch of the canopy into the support: you will hear a "click" when it is attached
correctly. Repeat on both sides(fig. 10).
Insert the front arch of the canopy into the front hinge: you will hear a "click" when it is attached correctly.
Repeat on both sides (fig. 11).
Fasten the Velcro flaps to the side and back of the seat (fig 12).
FITTING THE BUMPER BAR
Fitting the bumper bar (fig. 13, 14): Lift up the two attachment points for the handlebar, a CLICK will
indicate that they are locked. Line the bumper bar up with the slots and press on both sides. A click
indicates that it has been fastened correctly.
Removing the bumper bar (fig. 15): press button "a" on both sides of the bumper bar and at the same
time pull to remove it.
Opening the bumper bar on just one side (fig. 16): press button "a" on one side of the bumper bar
and pull to open it like a gate.
FITTING THE FOOTMUFF
(fig. 17, 18)
Insert the lower part of the footmuff on the seat of the chassis.
Fold the upper part of the footmuff around the bumper bar.
Secure the footmuff to the chassis of the pushchair using the press fasteners. Attach the press studs on
both sides.
23