Warnings And Notes; General Safety Instructions - Cleco DSRO Serie Manual Del Usuario

SP30-2056-LG1
12/20/2017
For this Instruction Manual
The original language of this manual is English and is
intended for all persons who will operate and maintain this
equipment.
This instruction manual has the following purposes:
• It provides important instructions for safe and effective
operation.
• It describes the function and operation of this equipment.
• It serves as a reference guide for technical data, service
intervals, and spare parts ordering.
Symbols in the text:
→ Identifies instructions to be followed.
• Identifies a list.
Bold Indicates an important feature or instruction.
Identification graphic:
Indicates a directional movement.
¢
Indicates a function or force.
ò
Copyright protection:
Apex Tool Group, LLC reserves the right to modify,
supplement or improve this document or the product without
prior notice. This document may not be reproduced in any
way, shape or form, in full or parts thereof, or copied to
another natural or machine readable language or to a data
carrier, whether electronic, mechanical, optical or otherwise
without the express permission of Apex Tool Group, LLC.
Safety:

Warnings and notes

Warning notes are identified by a signal word and a
pictogram.
• The signal word indicates the severity and probability of
the impending danger.
• The pictogram indicates the type of danger.
-------------------------------------------------------------
Indicates a potentially hazardous situation
WARNING!
for personal health and safety. If this warning
is not observed, death or serious injury may
occur.
-------------------------------------------------------------
Indicates a potentially hazardous situation
WARNING!
which, if not avoided, may result in minor or
moderate injury or property and environmental
damage.
-------------------------------------------------------------
GENERAL NOTE identifies useful information
that may include application tips but no
hazardous situations.
-------------------------------------------------------------
EN
Symbols on product
Be sure you understand their meaning before using this
equipment.
-------------------------------------------------------------
Read all instructions
-------------------------------------------------------------
Eye protection must be worn at all times during
the operation or maintenance of this tool.
-------------------------------------------------------------
Eye protection must be worn at all times during
the operation or maintenance of this tool.
-------------------------------------------------------------
CE compliant
-------------------------------------------------------------

General Safety Instructions

Designated Use
This tool is intended to be used as a hand held sander using
appropriate abrasives. It is always recommended that the
tool be used in a standing position and firmly gripped using
two hands.
Do not modify the tool, any guard, or accessory unless
approved in writing by Apex Tool Group, LLC.
Any abuse or misue of this tool or the abrasive
WARNING!
can be extremely dangerous. The abrasive
used with this tool are not manufactured or
supplied by Apex Tool Group, LLC. Consult
and comply with the safety practices provided
by the abrasive manufacturer.
Putting into service
Only fully trained personnel should install, adjust, operate,
or repair this tool.
Air supply
Connect the tool to a clean lubricated air supply capable of
providing a measured maximum air supply of 90 psig at the
tool with the tool running and the lever fully depressed. Use
a 3/8" I.D. air hose with a maximum length of 25 feet. Make
certain an air shut off valve is installed within reach of the
tool's workspace.
If the air supply is not equipped wth an airline lubricator the
tool must be manually lubricated. To manually lubricate the
tool, disconnect the air supply line at the tool and place 2-3
drops of suitable air line oil into the inlet fitting of the tool.
Manually lubricate the tool daily or if the tool begins to slow
down or lose power.
Page 2