PL12-48EA-H-LG1
10/19/2017
"15"
Torque Reaction Bar
"6"
Reaction bar and bracket should always be
used in higher torque applications such as
above 50 ft.-lbs. (68 Nm) or in closed-quarter
areas where injury to fingers could occur.
Unscrew Nut (5) and remove the Cover (6).
Install Bracket (1) and Splined Key (4). Re-
install Nut (5). Customer supplied Reaction Bar
bends to fit the application.
1
8
See Service Notes
"16"
Torque Reaction Bar
"7"
Reaction bar and bracket should always be
used in higher torque applications such as
above 50 ft.-lbs. (68 Nm) or in closed-quarter
areas where injury to fingers could occur.
Remove the Cover (7). Install Bracket (1) over
Gear Case hex. Install Locking Sleeve (5),
Washer (3), Bolt (2) and Nut (6). Customer
supplied Reaction Bar bends to fit the
application.
1
8
See Service Notes
EN
3
2
2
1
2
3
4
5
1
5
6
Page 72
Models:
48EA(E)110H(------)
48EA(E)135H(------)
8
1/2" Reaction Bar
• Application Specific
• Customer Supplied
4
6
5
Off
Models:
48EA(E)230H(------)
8
3/4" Reaction Bar
• Application Specific
• Customer Supplied
7
1
1
8