Publicidad
Idiomas disponibles
Idiomas disponibles
IMPORTANT
Please operate this function with schematic and correct testing procedure because applying voltage
arbitrarily may cause damage to components.
If you make a component power, press the switch of the multi-tester before touching the component
with the probe. This way you increase the lifetime of the switch.
Activate the components with auto motive electrical
disconnected.
By assisting Auto Circuit Tester tip with the ground test
lead, technician can activate the testing components
with automotive electrical system been disconnected.
This function can be used to test light, cooling fans, and
fuel pumps etc. To do this, please follow the procedure.
•
Connect the ground test lead with the negative
pole of the components.
•
Contact the Auto Circuit Tester tip with the
positive pole of the components. If the green
LED is on, it means the testing component is
conductible.
•
As the green LED goes on, please press the
polar switch forward and then release it quickly. If
the LED goes from green to red, you may
proceed further testing.
If the green LED turns off and red LED doesn't turns on,
or if the circuit breaker of the short circuit protection
tripped, it means Auto Circuit Tester has overloaded.
This may due to the following reasons:
The component is short circuit.
The component is a low resistance component.
If the circuit breaker of the short circuit protection has
tripped, it will auto-reset within no more than 60 sec.
Activate components with positive voltage
When technician tests the components, technician can
use Auto Circuit Tester to provide voltage to the testing
components. To do this, please follow the procedure:
•
Contact the Auto Circuit Tester tip with the
positive pole of the components. If the green
LED is on, it means the testing component is
conductible.
•
As the green LED goes on, please press the
polar switch forward and then release it quickly. If
the LED goes from green to red, you may
proceed further testing.
If the green LED turns off and red LED doesn't turns on,
or if the circuit breaker of the short circuit protection
tripped, it means Auto Circuit Tester has overloaded.
This may due to the following reasons:
The component is short circuit.
The component is a low resistance component.
If the circuit breaker of the short circuit protection has
tripped, it will auto-reset within no more than 60 sec.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Publicidad
