System Initialization - Sunjoy B201002700 Manual Del Usuario

After assembly of desk is complete, it is necessary to reset or initialize the motor system
1‐ Plug the power cord into an outlet or power strip, display will flash.
2‐ Press and continue to hold both the up (^) and down (v) buttons simultaneously, the display will show "E00"
when reaching 4'' to the lowest height, then followed by a beep and the desk is at its lowest height, the display
will show the lowest height. The buttons can be released now.
Notes
If initialization is interrupted by releasing buttons prematurely and display read "E00", of if the desk does not begin
moving, repeat step 2.
Gyro sensor anti‐collison system ensures safety during lifting, it will run in the opposite direction when encountering
obstacles or user slightly tap the table top edge (display read "E03"), or when the control box is not installed
properly (display read "E04"), please remove obstacles or check the control box installation to ensure the gyro
sensor anti-collison system works properly.
Over heating protection (display read "E01"), please stop operating and wait for 18 minutes.
3‐ Press the up (^) button to raise the desk to the highest position. Now release the button.
4‐ Press the down (v) button to lower the desk to the lowest position. Now release the button.
5‐ The system has now been successfully initialized the synced.
System Initialization