Bluetooth Connection; Connect A Microphone - N-Gear Disco Block 410 Manual De Usuario

- By connec ng the Micro USB Charging cable (included) to the back of the unit and USB to USB
Adaptr (not included) to an AC Power outlet.
- Charging me is about 5-6 hours in Power Off mode.
- In Charging mode, the back panel will show a red light indicator and when charging is completed,
the light will turn off.

BLUETOOTH CONNECTION

- Place the unit and your Bluetooth device no more than 10m apart.
- When powering on the unit, it goes into Bluetooth mode by default.
- Make sure the Bluetooth func on on your device is switched on.
- Set your device to search for the Bluetooth Pairing name N-Gear Disco Block 410.
- Once selected your device will indicate as "connected" and you will hear a sound prompt.
CONNECT VIA AUX
- Plug in the 3.5mm audio cable into the AUX input at the back panel of the speaker.
- You can connect to any audio device that has a 3.5mm audio output jack and can playback any
audio from this device.

CONNECT A MICROPHONE

- Plug your microphone (6.3mm plug) into the MIC input at the back panel of the speaker.
- Adjust the microphone volume on front of the speaker to your desired sound level.
LISTENING FROM USB DRIVE / MICRO SD
- Insert your USB s ck or Micro SD Card at the back panel of the speaker.
- Your speaker will automa callu playback music from your selected device USB or Micro SD.
Specifica ons
Peak Power 30W
Power input MicroUSB USB 5V,1A
Peak Power PMPO 30W