Duraworx DWX200 Manual De Instrucciones página 4

ASSEMBLY INSTRUCTIONS
Note: During assembly of each step of
assembly, assemble all hardware and hand
tighten. Once all the hardware is installed for
that particular step, tighten all the hardware.
1. Attach the rear axle frame of the rear axle
assembly (D) to the tray (A) using two
M8 x 40mm truss head bolts (CC), two M8
lock nuts (JJ), and two M8 washers (II).
Attach the left and right rear struts to the
tray using four M8 x 20mm truss head bolts
(BB), four M8 lock nuts (JJ), and four M8
washers (II), as shown in Fig. 1.
BB
I I
Hardware Used
BB
M8 x 20mm
Truss Head Bolt
CC
M8 x 40mm
Truss Head Bolt
JJ
M8 Lock Nut
I I
M8 Washer
4
Fig. 1
A
D
CC
JJ
x 4
x 2
x 6
x 6