Nolan N87 Seguridad E Instrucciones página 14

Ocultar thumbs Ver también para N87:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 42
VISOR
1.
Visor disassembly
1.1 Open the visor completely (Fig.1).
1.2 Push the release lever on the left side mechanism downwards until it stops (Fig.
2) and simultaneously remove the visor from the helmet, letting out first the lower
fastening "A" and then the upper fastening "B" from their respective housing in
the side mechanism itself (Fig. 3).
1.3 Follow the same steps on the right side of the helmet.
2.
Visor assembly
2.1 Place the left side of the visor on the corresponding side mechanism, inserting
the upper fastening "B" of the visor in the corresponding housing in the mecha-
nism itself and aligning the lower fastening "A" of the visor over the correspond-
ing housing in the mechanism (Fig. 3) .
2.2 Press the visor at the lower fastening "A" so that the release lever moves back-
wards and then place it back in position by attaching the visor to the side mech-
anism with a click (Fig. 2).
2.3 Follow the same steps on the right side of the helmet.
2.4 Close the visor completely.
WARNING
-
Make sure that the mechanisms are working properly. Open and close the visor
making sure that the mechanisms hold it in the different positions.
If necessary, repeat the above-mentioned steps.
-
Do not use the helmet if the visor has not been assembled properly.
-
Do not remove the side mechanisms from the shell.
-
Should any of the side mechanisms fail or be damaged, please refer to a Nolan
authorized dealer.
(Available as standard or accessory/spare part).
3.
Inner visor PINLOCK
3.1 Disassemble the visor (see instructions above).
3.2 Make sure that the inner surface of the visor is clean and check that the pin ad-
justment external levers are turned inwards (Fig.4).
3.3 Place the PINLOCK
Warning: The silicone-sealed profile of the PINLOCK
contact with the inner surface of the visor.
3.4 Insert one side of the PINLOCK
in position (Fig.5).
3.5 Widen the visor and fasten the other side of the PINLOCK
second pin (Fig.6).
3.6 Release the visor.
3.7 Remove the protective film from the PINLOCK
entire silicone-sealed profile of the inner visor adheres to the visor.
3.8 Fit the visor on the helmet (see instructions above).
assembly
®
inner visor on the visor.
®
inner visor on one of the visor pins and hold it
®
14
inner visor must be in
®
inner visor to the
®
inner visor and check that the
®

Publicidad

Tabla de contenido
loading

Tabla de contenido