Assembly Instructions; Tools And Parts - Gladiator GAWB66HWGG Manual De Instrucciones

Tools and Parts

Gather the required tools and parts before starting installation.
Tools Needed
1/2" (12.7 mm) socket
■
wrench for lag screws
Parts Supplied
Workbench top
■
Workbench legs
■
(two welded pairs)
Right angle brace
■
Left angle brace
■
IMPORTANT: The pre-drilled holes on the underside of the workbench top are along the rear edge of the workbench.
1.
Place legs
With the single rivet nuts facing inward and the two rivet nut
holes per leg to rear of the bench, place each pair of legs
on the underside of the workbench top. Align the holes in
the plate with the pre-drilled holes in the workbench top.
4

ASSEMBLY INSTRUCTIONS

Leveling feet (4)
■
5/16" (7.94 mm) Allen head
■
bolts (6)
1 / " (2.9 cm) lag
1
■
8
screws (12)
Allen wrench
■
Install Legs and Angle Braces
Workbench Use Requirements
WARNING
Excessive Weight Hazard
Use two or more people to move and assemble
workbench.
Failure to do so can result in back or other injury.
Intended for use in a garage.
■
Maximum weight limit is 1,500 lbs (680 kg) for the workbench.
■
Unpack the Workbench
1. Unpack the legs, braces, and hardware from the box. Verify
contents. See the "Parts Supplied" section.
NOTE: Leave the workbench top on the cardboard during
assembly.
2. Remove the corners from the workbench top. The pre-drilled
holes should be visible.
3. Dispose of/recycle all packaging materials.
2.
Fasten legs to workbench top
Using eight lag screws (four screws per pair), fasten the
legs to the workbench top. Do not completely tighten the
screws.