EUROM PAC 12 Folleto De Instrucciones página 15

1 - ON/OFF button (POWER)
2 – Temperature up button
3 - Temperature down button
4 – Receiver remote control
(only on operational panel)
6 – Fan speed button
The operational panel also has a display (Led window) that shows any values set:
Before using the air conditioner, check:
 That it has been installed according to safety instructions
 That it is not damaged or broken
 That the electrical socket that you wish to use has the same voltage as is given on the unit's
specification plate (220-240V / 50Hz)
 That no other devices are connected to the same socket
If this has all been checked, you can insert the plug into the socket. Start the unit by pressing on
the ON/OFF button.
Use the Function selector button to choose a specific function:
automatic function, cooling or dehumidifying. Every time you press the button, the function
changes. The display shows which function is active. If you are cooling or dehumidifying, wait
for up to 3 minutes after switching on or off before switching the unit on or off again. The
compressor needs this time to recover.
Automatic cooling:
Press function selector button until the 'AUTO' icon is shown

The device will try to maintain the temperature at 23°C in an energy-efficient manner: by
dehumidifying up to 26°C and by cooling above 26°C.
Cooling:
Press function selector button until the 'cooling' icon is shown

Press temperature buttons ▲or ▼to set the required temperature (from 16°C to 31°C)


Press fan speed button to select desired fan speed.
Dehumidifying:
Press function selector button until the 'dehumidifying' icon is shown. Check that the water

outlet hose is correctly connected, see page 6!
Set the room temperature using the temperature ▲or ▼buttons 2 degrees lower than the

current room temperature (16°C to 31°C).

Set fan speed to low.
15
7 - Timer button
5 – Function selector button
8 - WF – 'Tank full' light
(only on operational panel)
9 – Battery cavity (CR2025, 3V)
(only in remote control)
1 – automated function
2 – fan speed button
3 – cooling
4 – set temperature/time
5 – timer on
6 – temperature °C
7 – dehumidify