Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Do not wash detachable equipment assemblies in a dishwasher.
Equipment shall be cleaned as follows:
1.
Remove the jar from the motor unit and rinse it with water jet to remove large food rem-
nants.
2.
Place the jar on the motor unit. Fill the jar with 1-1.5 cups of warm soapy water, close the
cover and turn on the blender at high speed for a few seconds.
3.
Remove the jar from the motor unit and rinse thoroughly with clean water. Repeat the
procedure if necessary.
4.
Wipe the motor unit with a clean wet sponge or cloth.
SAFETY
1.
Equipment shall be installed and connected to the power mains by skilled professionals
only.
2.
Use a three-wire circuit with grounding to connect mono-phase equipment.
3.
The equipment is not intended for outdoor use.
4.
The equipment shall be installed on a stable support 800-900 mm in height with flat level
surface. The surface shall be dry and clean. The support shall withstand the equipment
weight.
5.
The equipment must be installed away from heat sources (electric burners, gas burners,
radiators, etc.).
6.
To ensure good ventilation, the distance between the equipment and the wall or any adja-
cent structures shall be at least 5 cm.
7.
Ensure that the electric cable does not hang over the edge of the support and is away from
sharp, hot objects and open flame. Do not twist or deform the cable. Never pull the cable
when disconnecting the power, always pull out the plug. Do not take the cable and the
male connector with wet hands. Do not immerse plug and cable in water or any other liq-
uid. Do not operate the equipment if the power cable or the plug is damaged.
8.
As extra safety precaution, the equipment is equipped with a short power cable. This min-
imizes the risk of the cable hanging over the edge of the support, and the user getting
caught in the cable, stumbling over it or accidentally pulling it. To avoid electric shock, in-
juries and equipment damage, the use of extension cables is strongly discouraged.
9.
The equipment is designed for grinding, mixing, and whipping various food products. The
equipment shall not be used for any purposes other than intended.
10. The equipment may not be turned on of the jar is not set in the operating position.
ATTENTION! If the jar is installed incorrectly, the equipment will not turn on. Make sure
the jar is firmly fixed on the motor unit.
11. An idle operation of the equipment (i.e. with an empty jar) is not allowed.
12. It is not allowed to put metal objects (knives, forks, spoons, etc.) in the jar.
13. When filling the jar, keep in mind that the volume of whipped mix increases. Avoid over-
filling the jar.
14. As the motor rotates at high speed, it is recommended to hold the cover during processing
to prevent the jar from displacing.
15. The blender cover shall be closed during operation. Do not try to open the cover and put
your hands or other objects into the blender jar while the motor is running.
12
Publicidad
Tabla de contenido
