Unpacking Instruction; Power Supply - Beamz BBP94 Manual De Instrucciones

UNPACKING INSTRUCTION

CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are
present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if
any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing
materials. In the event that the product must be returned to the factory, it is important that the product be returned in the original
factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
On the label on the backside of the product is indicated on this type of power supply must be connected. Check that the mains
voltage corresponds to this, all other voltages than specified, the light effect can be irreparably damaged. The product must also
be directly connected to the mains and may be used. No dimmer or adjustable power supply.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
RECHARGEABLE BATTERY OPERATION
Prior to operating the device off mains for the first time, the rechargeable battery must be fully charged.
1 Switch on the device with the power switch. The operating time of the battery depends on the operating mode and the ambient
temperature. After the operation, switch the device off.
2 For charging the battery, connect the device to a power outlet via the enclosed adapter (12.6Vdc 2A). The device may be
operated during the charging procedure.
3 The device features a protective circuit for charging which prevents overload of the rechargeable battery. However, disconnect
the device from the mains after charging. Otherwise there will be a low current consumption even if the device is switched off.
4 The device will heat up during charging; this is normal.
5 To prevent damage to the battery by deep discharge, recharge a battery completely discharged as soon as possible. Do not
store the unit with the battery completely discharged and regularly recharge the battery in case of long storage.
INSTALLATION
CAUTION:
Attention:
•
The installation of the product has to be built and constructed in a way that it can hold 10 times the weight for 1 hour
without any harming deformation.
•
The installation must always be secured with a secondary safety attachment, e.g. an appropriate catch net. This
secondary safety attachment must be constructed in a way that no part of the installation can fall down if the main
attachment fails.
•
Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging and servicing.
•
The operator has to make sure that safety-relating and machine-technical installations are approved by an expert
before taking into operation for the first time and after changes before taking into operation another time.
•
The operator has to make sure that safety-relating and machine-technical installations are approved by a skilled
person once a year.
•
The fixture should be installed in the position where persons cannot reach and where persons may walk by or be
seated.
CAUTION:
Please consider the respective national norms during the
installation! The installation must only be carried out by an
authorized employee or dealers!
When installing the device, make sure there is no highly in
inflammable material (decoration articles, etc.) in between a
distance of min 0.5 meter.
3