Siemens SITRANS FC410 Inicio Rápido página 6

Connecting
Note
End Of Line (EOL) termination
The FC410 EOL termination DIP switch is default set to EOL active. To change termination setting see Setting the EOL
termination DIP switches (Page 8).
M12 version
The sensor is provided with a preformed cable terminated with M12 style stainless steel weather-proof plugs.
The cable screen is physically and electrically terminated within the body of the plug.
Take care when handling the cable and passing it through cable ducting that the plug is not subjected to excessive tension
(pulling) as the internal connections may be disengaged.
Note
Never pull the cable by the plug - only by the cable itself.
1. Connect the sensor using the supplied 4-wire cable with M12 connectors.
Note
Grounding
The sensor cable screen is mechanically connected to the grounding terminal (PE), only when the M12 plug is correctly
tightened.
Terminal number
1
2
3
4
Cable termination version
A: Prepare the cable by stripping it at both ends.
Figure 4-1 Cable end
B: Connect wires within the sensor terminal space
1. Remove the lock screw and remove the lid.
2. Undo the flexible strap.
3. Disconnect the sensor connection (white plug) from the electronic.
4. Loosen the mounting screw using a TX10 Torx driver and remove the electronic from the housing.
5. Remove the cap and the ferrule from the cable gland and slide onto the cable.
6. Push the cable through the open gland and anchor the cable shield and the wires with the clamp bar.
7. Remove the terminal block from the electronic.
6
Description
24 VDC
0 VDC
B
A
Wire color (Siemens cable)
Orange
Yellow
White
Blue
SITRANS FC410 flowmeter
A5E33120231-001, 12/2013