Global Settings - HEADRUSH MX5 Guia De Inicio Rapido

To reverse looper playback, tap the button next to the Playback field and then turn the
encoder.
Tip: Create eerie effects by recording layers in reverse then switching back to normal playback.
To set the looper's location, tap the button next to the Playback field and then turn the
encoder to place it before (Pre) or after (Post) the signal chain. Moving the looper to the Pre
position enables you to edit your rig without having to play the same riff over and over again.
To exit the looper and return to the main screen, press the Exit footswitch. If the looper is
playing, playback will continue.
To re-enter the looper, press and hold the Looper footswitch again.
Tip: Use this feature to create different effect configurations (adjust parameters,
activate/deactivate models, etc.) for each layer, creating a multi-textured performance. You can
also switch rigs while using the looper and use a different rig for each layer.

Global Settings

Use the global settings to configure the HeadRush
MX5's overall operation.
To show the global settings, tap the 
button in the upper-right corner of the screen,
and tap Global Settings.
To select each page of the global settings,
tap the number at the upper-right corner of
the screen.
LCD Brightness: This setting determines the brightness of the main display. Tap this field, turn
the encoder to select 1 (dim) through 5 (bright), and then press the encoder.
Audio Configuration:
Rig Input: This setting determines whether each rig's input signal is taken from the Guitar
Input (Guitar) or the left (L) Return Input (FX Ret L). When set to Per Rig, the source is
determined by the Rig Input setting of each rig in the Input block. When set to FX Ret L
or Per Rig, the FX-Loop Stereo Return setting will be disabled; the signal will be mono.
Main Out Level: This setting determines the signal level sent to the main Outputs
(1/4"/6.35 mm, TRS). When set to Line, the output level will be +18 dBu. Use this setting
if you are connecting the HeadRush MX5 to a full-range, flat-response amplifier, PA
speaker, mixer, or audio interface. When set to Amp, the output level will be +6 dBu. Use
this setting if you are connecting the HeadRush MX5 to a traditional guitar amplifier.
FX Return Level: This setting determines the signal level received by the FX Return Input
(1/4"/6.35 mm, TRS). When set to Rack, the output level will be line level, +18 dBu. Use
this setting if you are connecting a rack effects processor in the HeadRush MX5's FX-
Loop. When set to Stomp, the output level will be +6 dBu. Use this setting if you are
connecting a traditional guitar pedal ("stompbox") in the FX-Loop.
FX-Loop Stereo: These settings determine whether the incoming and outgoing signal in
the effects loop is stereo or mono. Tap Send to enable or disable the stereo signal for
the Send Outputs. Tap Return to enable or disable the stereo signal for the Return
Inputs.
17