Cleaning, Care & Maintenance - Buffalo GD220 Manual Del Usuario

Telephone Helpline: 0845 146 2887 (United Kingdom)
Switching Between Hot and Cold Wet Towels
The initial state of the dispenser after start up is for cold towels.
To dispense hot wet towels, press the 'hot' key. The red indicator light will illuminate to show hot
mode has been selected.
To return to dispensing cold towels press the 'hot' key again. The red indicator light will switch off to
show cold mode has been selected.
Please note: When using the machine for the first time run the dispenser in cold mode first until wet
towels are dispensed. This insures that there is water in the heating cylinder. SELECTING THE HOT WET
TOWEL MODE WHEN THERE IS NO WATER IN THE HEATING CYLINDER MAY CAUSE SEVERE DAMAGE TO
THE MACHINE.
Towel Length Adjustment
The length of the towel can be set from the shortest (1), to the longest (5). The factory setting is set at 3.
Press the 'length' key. Each press of the length key will cycle through the lengths 1-5. The length
selected will be displayed in the LED display.
Adjusting Towel Moisture
The towel moisture volume can be set from the driest (1) to the wettest (6). The factory setting is set at
grade 3.
Press the 'humidity' key. Each press of the humidity key will cycle through the moisture settings 1-6.
The moisture setting selected will be displayed in the LED display.
Cleaning, Care & Maintenance
Before cleaning takes place the dispenser should be disconnected from the electricity supply by removing
the plug from the socket.
Wipe external surfaces with a clean damp cloth.
Regularly drain the machines internal water system by unscrewing the drain nut to discharge the water
collected in the water receiver.
Telephone Helpline: 0845 146 2887 (United Kingdom)