Happyhotfeet R4-202 Manual página 3

Manual for Happyhot insoles - Version R4-202
GB
After unwrapping the Happyhotfeet insoles, charge with the USB micro cable using a mobile charger or power bank. Charge for approx. 4 hours for the initial charge.
Insert the charging cable into the insole back heel. Connect 220V or the USB power bank. When charging is initiated, the LED will be red. After approx. 4 hours,
the LED will change to a green light or a flashing green.
After completed charging, the Happyhotfeet insoles are ready to synchronise. This should only be done the first time they are used. The remote will then be used
to turn on and off.
Synchronisation of your insoles
Press the on/off key at the insole heels twice. The LED will flash red/blue/green. Press the on/off key on the remote once. The LED will turn red, and the insoles have
now been synchronised and are ready for use.
The remote is used to turn the Happyhotfeet insoles on and off. Press on the requested heating level - the LED will flash in red for approx. 1 second.
The insoles are now on and can be adjusted for three heating levels - HIGH - MIDDLE - LOW.
To turn the Happyhotfeet off again, press the on/off key for 3 seconds. The LED will flash for 2 seconds. The Happyhotfeet insoles have now been turned off.
Turn the insoles on without the remote
If you lose or forget the remote, the Happyhotfeet insoles can be turned on as follows: Press on/off on the heel for approx. 5 seconds until the LED flashes in red.
The insole is now at HIGH level. For a different heating level, press the on/off key until blue or green.
HIGH = RED
MIDDLE = BLUE
LOW = GREEN
To turn the insole off after use, press the on/off key again for 5 seconds. The insole will turn off. When turned off manually, the LED will flash in 3 different colours
depending on how much power is left on the battery.
Red: Battery level 0-33% Blue: Battery level 34-46% Green: Battery level 47-100%
Before placing the Happyhotfeet inside footwear, remove all existing insoles to ensure the proper fit for the Happyhotfeet insoles. Select the size on the back -
MEN 41-46 and LADIES 35-40. When the correct size has been found, cut along the line on the insole where the size is shown.
Warning:
Be careful before cutting. Do not cut outside the solid line on the insole. Do not bend excessively. This may/will damage the heating element and the Happyhotfeet
insoles.
After use:
Remove the Happyhotfeet insoles from the footwear after use. Recharge the insoles before the next use.
For the best battery performance, it is recommended to not charge the batteries 100%. If the insoles are not to be used for a while: Charge for 20 minutes and again
every 3 months for approx. 20 minutes. The insoles must be regularly charged when not used to maintain the battery voltage.
When using the Happyhotfeet insoles regularly again, charge the batteries 100%.
Daily/care directions:
• Power off the Happyhotfeet insoles when not in use.
• Only charge the Happyhotfeet insoles when they are not placed in footwear.
• Avoid damaging the heating element from bending the Happyhotfeet insoles.
• Clean with damp cloth. Do not immerse the insoles into water.
• Do not place the insoles directly on a heater. Leave the insoles to dry naturally.
Have fun.