Publicidad
Idiomas disponibles
Idiomas disponibles
• Observe the pressure rating provided by the manufacturer.
• Designed for use with DOT 3, DOT 4 and DOT 5.1 brake fluids only. NO LHM.
• Minimum level of required DOT : 1liter.
• Brake fl uid is corrosive and may damage the paint and bodywork of your vehicle.
• The vehicle must be on a fl at surface, a platform or rest on its wheels.
• Check the condition of the brake lines and change them if required.
• When bleeding brakes under pressure, apply manufacturer instructions scrupulously.
• After bleeding the circuit, check the brakes operate properly.
• Do not use used brake fl uid or new fl uid stored in a non-closed can.
• Clean the fi lter approximately every 3 months. (Filter reference: DF.80/100-02).
• Air present in the braking circuit may cause partial or total loss of braking, and cause a severe or lethal accident.
• Never use the brake system bleeder in a horizontal position.
• The DOT tank is integrated into the body of the brake system bleeder. DO NOT DRILL as there is a risk the liquid will leak out.
1
4 4
4
ON
6
Position the tip of the collection can onto the bleeding screw. Open the bleed screw. Bleed the circuit, one caliper after another,
Position the tip of the collection can onto the bleeding screw. Open the bleed screw. Bleed the circuit, one caliper after another,
Position the tip of the collection can onto the bleeding screw. Open the bleed screw. Bleed the circuit, one caliper after another,
Position the tip of the collection can onto the bleeding screw. Open the bleed screw. Bleed the circuit, one caliper after another,
10
according to the sequence in the vehicle manufacturer's manual.
NU- DF.101_0417.indd 4
EN. Technical specifications- Safety instructions
Weight in operating order (tank full) : 25kg
Housing : HDPE
Tank capacity : 10l
Power supply cable length : 4m
2 2
2
Starting bleeding and adjusting pressure
7 7
7
11
Use
OEM
3 3
3
5 5
5
8 8
8
4
"CLIC"
START
9
03/04/2017 15:03:50
Publicidad
