How To Operate - Igloo IUF3WH Manual De Instrucciones

HOW TO OPERATE

Before first use, remove all adhesive tape from the drawers, shelves and trays.
INSTALLATION
1. The freezer should be placed on a completely flat surface. Allow 1 foot of space on each side
of the freezer and between the freezer and the wall. Also allow at least 8 inches of space
between the top of the freezer and the ceiling.
2. Choose a location for your freezer that is not exposed to sunlight, high temperature or
humidity, as humidity may stain and damage the freezer.
3. The appliance can be adjusted by rolling the two legs in the bottom front of the freezer if it
becomes unstable. Raise the freezer by rolling the adjustable feet clockwise.
4. The surface of the location where the freezer is installed should be firm and flat. If freezer is
not secured in a proper location, noise and vibration may occur. The noise may be increased
if the floor is not firm. If you have to position the freezer on a carpeted floor, place a sheet
underneath the freezer, such as plywood or a plastic mat, to prevent heat emissions from
ruining the carpet.
5. Make sure that legs are pressed firmly into the floor and allow the freezer to lean backward
slightly so that the doors remain closed.
DOOR ALIGNMENT
1. Remove the top hinge cover using a flat head screw driver. Gently lift from the rear of the
hinge and slide forward.
2. Loosen the top hinge screws using a Phillips head screwdriver.
3. Adjust the door or put a spacer in between and then tighten the screws.
4. Replace the top hinge cover by aligning the rear of the cover with the rear of the hinge.
Press firmly on the front of the cover until it snaps into place.
PLACEMENT OF FOOD
1. There should always be some space between items inside for air circulation.
2. Food should be kept in sealed containers to avoid becoming dry, spoiled or creating odors
in the freezer.
3. Hot food should be cooled down before placing into the appliance. Otherwise, bacteria will
grow in food.
4. Reducing the frequency of opening the doors can lower the electronic consumption.
NOTE: Do not use any electronic equipment inside the appliance.
ADJUSTING TEMPERATURE
The temperature of the freezer can be controlled manually by the thermostat dial. As a
general rule, it is best to set thermostat at 2.
OFF
Unit is turned off.
1 Lowest cooling intensity (least cold)
2
Medium cooling intensity
3
Highest cooling intensity (most cold)
DEFROSTING
Heavy frost will effect the efficiency and performance of the freezer and can create
8