Publicidad
Idiomas disponibles
Idiomas disponibles
26. Step Seq/Config: Press this button to open Step Sequencer View, which allows you to
view notes and drum patterns on a timeline. Press this button repeatedly to cycle through
three different views.
Press Shift and press this button to configure the Step Sequencer's settings.
27. Edit Buttons: Press and hold one of these buttons to edit a clip or track according to the
following:
• Select: Press and hold this button to view the currently select clip. While holding,
tap another Clip Launch Pad to select another clip.
• Edit: Press and hold this button then tap a Clip Launch Pad or Track Selector
button to edit a clip or track, respectively.
• Copy: Press and hold this button to copy a clip or track. While holding, tap the Clip
Launch Pad or Track Selector button of the clip or track you would like to copy,
then tap a new pad or button to copy it.
• Delete: Press and hold this button then tap a Clip Launch Pad or Track Selector
button to delete it.
28. Arp/Config: Press this button to enable or disable the internal Arpeggiator, whose rate is
based on the current Tempo and Time Division settings.
Press Shift and this button to configure the Arpeggiator's settings.
29. Tap Tempo: Tap this button at the desired rate to enter a new tempo.
30. Track Selectors: Press one of these buttons to select a track, represented by the
column of clips just above it. The right-most button (labeled Master) selects the Master
track.
Press and hold Shift and then press one of the first eight Track Selectors to select a
Global Quantization setting: None, 8 Bars, 4 Bars, 2 Bars, 1 Bar, 1/4, 1/8, or 1/16.
31. Assign Mode Buttons: Press one of these buttons to set the function of the Track
Assign buttons when pressed:
• Mute: Press this button to mute the track.
• Solo: Press this button to solo the track.
• Rec Arm: Press this button to record-arm the track.
• Clip Stop: Press this button to stop the clip that is playing in the track.
32. Track Assign: Press one of these buttons to apply an assignment to a track, represented
by the column of clips just above it. Use the Assign Mode buttons to set the assign
function.
Press and hold Shift and then press one of these buttons to access secondary functions,
printed below the buttons.
33. Stop All Clips: Press this button to stop all clips when they reach the end.
8
Publicidad
