Care And Maintenance - gartenpirat GP1350 Manual Del Usuario

Step 8: Assemble Seat (M) x 2 and Back Rests (M) x 2
8-1.
Using bolt (A) x 16 + spring washer (D) x 16 and domenut (E) x 16, fasten the
Back Rests (M) x 2 onto the Seat Back Support (J) and fasten the Seats (M) x 2 unto Upper Pipes (H).
Step 8-2.
8-2.
Insert the Plastic End Caps (O) x 4 onto the top of the Seat Back Supports (J).

CARE AND MAINTENANCE

1. This equipment must be assembled and checked by an adult.
2. Regularly check all nuts and bolts for tightness before use and replace any worn, defective
or missing parts. DO NOT try to repair broken parts.
3. Regularly check seats, steel tubes and other parts are tightened completely. Replace worn and
damaged parts when necessary.
4. Remove worn and damage parts and refrain from using the seesaw until replacement parts
are replaced.
5. At the beginning of each season, oil all metal parts to maintain and do so regularly
when necessary during the use.
6. Seesaw set placement:
(a) Place this equipment on a level surface at least 2 m from any structure
or obstruction, such as a fence, garage, house, overhanging branches, laundry line or
electrical wires.
(b) Do not install this equipment over concrete, asphalt or any other hard surface where
the metal parts may be scratched or scraped.
(c) Place this equipment in a well-lit area.
7. Seats should be kept dry. Do not use when they are wet.
8. This item is not designed for adults. The maximum combined weight of 2 children should not
exceed 70 kg.
9. Retain these instructions for future reference.
10.Keep this equipment clean and free of debris and dirt.
Step 8-1.
Step 8-2.
Plastic End Caps (O)
Page 7 of 7