CARE AND MAINTENANCE
All maintenance should only be carried out by a qualified service technician.
Care of Accessory
Accessory should be stored in an organized way so can be removed without disturbing or
damaging other accessories with their safety information.
Store in a place that is cool and dry, away from direct sunlight and excess heat or cold.
Cleaning
Before cleaning or performing any maintenance, remove the battery pack from the tool.
For safe and proper operation, always keep the tool and its ventilation slots clean.
Always use only a soft, dry cloth to clean your screwgun; never use detergent or alcohol.
TROUBLESHOOTING
WARNING
• Make sure that the slide switch (D) is in the "OFF" position and detach the battery pack from
the tool before performing troubleshooting procedures.
PROBLEM
The tool does not
work.
Wheels cannot be
installed.
Motor overheating.
POSSIBLE CAUSE
Low battery capacity.
Battery overheating.
Wrong size.
Cooling vents are obstructed.
CORRECTIVE ACTION
Charge the battery pack.
Release the switch, wait for the
battery to cool down, then start
the tool again.
Replace wheels with correct size.
Clean and clear vents. Do not
cover vents with hand during
operation.
15