Publicidad
Idiomas disponibles
Idiomas disponibles
1. Remove the two outer M8 floorboard bolts, figure 1. Keep
the M8 nuts for reassembly.
W A R N I N G
IMPACT AND MOVING PARTS ENTANGLEMENT HAZARD
Failure to observe these instructions could lead to severe injury or death
•
Always remove jewelry and wear eye protection.
Read installation and operating instructions thoroughly.
2. Place the 1/4" spacers (B5) into position over the
floorboard bolt holes, figure 2.
3. Place the plow mount (A1) into position over the spacers
(B5), figure 3. Loosely secure the plow mount with two M8
X 45mm bolts (B4), 5/16" washers (B2), and the M8 nuts
removed in step 1.
Note: Do not tighten at this time.
Note: On the 475cc (500) models, trimming of the plastic
may be required to get placement of the mount positioned
correctly to mark location of the u-bolts.
©2011 Warn Industries, Inc.WARN® and the WARN logo are trademarks of Warn Industries Inc.
I N S T A L L A T I O N I N S T R U C T I O N S
Figure 1 - Remove Bolts
Figure 2 - Position Spacers
A1
Figure 3 - Plow Mount Location
4
Remove
B5
B4 & B2
76454 A1
Publicidad
