Siemens 4AI I 4WIRE HART Informacion De Producto página 9

English
Assembly
•
Check that the electronic submodule is not damaged.
Only connect undamaged electronic submodules to the
TM-E terminal module.
•
The first time that an electronic submodule is inserted, the
coding elements on the terminal submodule will snap in
which prevents the insertion of the incorrect submodule.
This mechanical coding may not be changed.
•
In Zone 1 and Zone 2, the electronic submodules may be
inserted and removed during operation. The enclosure
(Ex e / IP 54) in which the ET 200iSP is found may only be
opened briefly for this purpose (see the ET 200iSP
manual).
•
In configuring the ET 200iSP, you must consider the
permissible number of electronic submodules (see the
ET 200iSP manual, chapter 3.6).
Commissioning
•
The relevant national regulations must be observed when
commissioning the system.
•
When checking the functionality of the equipment, observe
the EN 60 079-17 guidelines. This standard includes the
regulations found in the international standard
IEC 60 079-17.
A5E00308246-05 English