Klarstein AMELIA Manual De Instrucciones página 28

EN
28
Ducted mode air exhaust system
CAUTION
Risk of fi re! To reduce the risk of fi re, use metal ductwork only.
1. Decide where the ductwork will run between the
hood and the outside.
2. A straight, short duct run will allow the hood to
perform most effi ciently.
3. Long duct runs, elbows, and transitions will
reduce the performance of the hood. Use as
few of them as possible. Larger ducting may be
required for best performance with longer duct
runs.
4. Attach an adequate length of Ø 150 mm round
duct to the air outlet adapter.
5. The air must not be discharge into a fl ue that
is used for exhausting fumes from appliances
burning gas or other fuels. Regulations
concerning the discharge of air have to be
fulfi lled.
6. Install a roof/wall cap. Connect round metal
ductwork to cap and work back towards
hood location. Use duct tape to seal the joints
between ductwork sections.
Recirculation Mode
CAUTION
Risk of fi re! Do not use plastic or rigid metal ducting.
1. Install the charcoal fi lter on (see section "Cleaning and Maintenance").
2. Please note that the air will fl ow out from the two grids on the two sides of the
decorative chimney bottom.