Briggs & Stratton 20522 Guía De Configuración Rápida

WARNING Failure to read and follow the operator's
manual and all operating instructions before
using could result in death, serious injury,
and/or property damage.
WARNING Risk of electrocution. Contacting both
power conductors, at the same time could
cause electric shock or burn resulting in death
or serious injury.
• Connect only to a properly grounded outlet. DO NOT
remove ground pin from plug.
• Inspect cord before each use, DO NOT use if cord is
damaged.
• Keep all connections dry and off the ground.
• DO NOT touch plug with wet hands.
Items Included:
Operator's Manual (not shown)
Spray Gun
High Pressure
Pressure
Hose
Gauge
Master ON/OFF
Switch
Electric Cord
with GFCI
Air Hose
Water
Inlet
Stability Foot
Items NOT included that you will need:
• #2 Phillips screwdriver • Safety goggles (indirect vented type)
• Garden hose, 50 feet (15 m) or less • Petroleum or synthetic grease
Unpack Electric Pressure Washer
1. Remove everything from carton.
2. Ensure you have all included items prior to assembly. If items are
damaged or missing, call 1-800-743-4115.
3. Prior to assembly, lubricate the rubber o-ring seals on all
connections with petroleum or synthetic grease. See Operator's
Manual, Lubricate O-Rings.
8 9 10 11 12
Assemble Main Unit
1. Remove and discard the protective cap (A) from each wheel
shaft.
1
NOTICE During shipment wheel tabs may compress inward. If so,
gently spread tabs outward.
2. Slide wheel shafts (B) into holes at sides of main unit. Wheels are
installed correctly when you hear a CLICK and they are securely in
place.
2
3. Slide the handle (C) into the slots at top of main unit. Install two (2)
screws to secure the handle to the main unit.
4. Slide accessory tray (D) into slots at back of main unit. Install two
(2) screws to secure the accessory tray to the main unit.
5. Install stability foot (E), and secure using two screws.
6. Place detergent bottle (F) onto shelf at back of unit.
7. Rotate detergent bottle cap (G) counter-clockwise until it clicks onto
retaining tab. Make sure that end of suction hose contacts bottom of
bottle.
7
Copyright © 2013. All rights reserved. No part of this material may be reproduced or transmitted in any form without the express written permission of Briggs & Stratton Power Products Group, LLC.
Every effort has been made to ensure that the information in this document is accurate and correct. However, we reserve the right to alter or otherwise improve the product and this document at any time without prior notice and without incurring obligation.
This pressure washer is rated in accordance to the Pressure Washer Manufacturers Association (PWMA) standard PW101-2010 (Testing and Rating Performance of Pressure Washers).
Quick Setup Guide
with Electric Inflator Function
WARNING High water pressure could cut through
skin resulting in serious injury. Spray gun
traps high water pressure, even when motor
is stopped and water is disconnected. NEVER
aim spray gun at people, animals, or plants. ALWAYS
point spray gun in safe direction, press red button and
squeeze trigger to release high pressure, every time you
turn off pressure washer.
WARNING Risk of bursting. High pressure air could
result in death or serious injury.
• Follow manufacturer's instructions on items to avoid
over inflation.
• Use only recommended air-handling parts acceptable
for pressures not less than 250 PSI.
• Do not leave inflator unattended while running.
Metal Wand
Detergent
Bottle
Accessory
Tray
Spray Tips (3)
Nozzle and
Spray Tip
Cleaner
Water Outlet
1
2
B
3 C
3
4
5
4
6
5
E
6
7
Electric Pressure Washer
Connect Hoses and Water Supply
1. Attach garden hose (50 ft. / 15.24 m maximum) to water supply.
2. Run cold water through garden hose for 30 seconds to flush the
hose of debris. Turn off water.
3. Confirm that black rubber gasket (H) is installed in water inlet located
at lower front of unit.
NOTICE DO NOT run the pump without the water supply connected and
turned on.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
4. Attach opposite end of garden hose (J) to the water inlet coupling
(K). Tighten by hand.
5. Attach high pressure hose (M) to the unit's water outlet (N) located
at lower back of unit. Tighten by hand.
6. Attach opposite end of high pressure hose to the spray gun. Press
red button (P) on spray gun, then insert end of high pressure hose
(M) into gun until it SNAPS into place. Release the red button and
make sure connection is secure.
Connect Wand and Spray Tips
1. Turn ON water, point gun in a safe direction, press trigger release
(U), then squeeze trigger (V) to purge pump system and spray gun
of air and impurities.
2. Insert and twist wand (Q) into spray gun (R). Once wand slides
into gun, apply further inward pressure to wand and twist 1/4 turn
clockwise until securely in place.
3. When the metal wand is installed, select spray tip you want to use.
Pull back on collar of wand (S), insert spray tip (T) and release
collar. Tug on spray tip to make sure it is securely in place.
NOTICE For spray tip instructions, see operator's manual.
How to Start Your Electric Pressure
Washer
1. Put on safety goggles.
Turbo
WARNING Risk of eye injury. Spray could splash back or propel
Wand
objects resulting in serious injury. Always wear indirect
vented (chemical splash) safety goggles marked to comply
with ANSI Z87.1 when using or in vicinity of this equipment.
NEVER substitute safety glasses or dry-condition goggles for indirect
vented safety goggles.
2. Turn on water.
NOTICE DO NOT run the pump without the water supply connected and
turned on.
3. Press the master ON/OFF switch (W) to the OFF (O) position.
WARNING Risk of electrocution. Use of an extension cord could
cause electric shock or burn resulting in death or serious
injury.
• DO NOT use an extension cord with this electric pressure washer.
Your home's electrical circuit receptacle or extension cord may not
provide lifesaving ground-fault circuit-interruption protection.
A
4. Plug electrical power cord into an electrical circuit rated for 120
Volts AC at 15 Amps that is properly installed and grounded in
accordance with all local codes and ordinances.
light (Z) on the GFCI should appear.
WARNING Risk of electrocution. Non-operating ground fault
circuit interrupter (GFCI) could result in death or serious
injury. If indicator light does not stay on after test and reset,
B
do not use GFCI.
NOTICE The indicator light must be ON for the electric pressure washer
to operate.
5. Press TEST button (X). The indicator light (Z) should
be OFF.
16
6. Press RESET button (Y). The indicator light (Z) should
be ON.
16
NOTICE DO NOT use the electric pressure washer if above test fails.
7. Press the master ON/OFF switch (W) to the ON position (–).
NOTICE Before using the Electric Inflator function, Electric Inflator
ON position (=), see How to Use the Electric Inflator Function in the
Operator's Manual.
8. Point gun in a safe direction, press trigger lock button (U) and
squeeze trigger (V). The electric pressure washer motor will start
and stop as spray gun trigger is depressed and released.
D
How to Stop Your Electric Pressure
Washer
The electric pressure washer motor runs only when the trigger is
engaged. To stop the electric pressure washer and turn off the motor:
1. Release spray gun trigger (V).
2. Press the master ON/OFF switch (W) to the OFF (O) position.
NOTICE Releasing the trigger will shut off the motor but does not shut
off electrical power to the unit.
3. Turn off water supply.
4. ALWAYS point spray gun in a safe direction and squeeze spray gun
trigger (V) to relieve built up pressure in the unit.
F
NOTICE Spray gun traps high water pressure, even when motor is
stopped and water is disconnected.
5. Disconnect GFCI plug from outlet.
6. Coil power cord and high pressure hose and place on accessory tray.
7. For long term storage instructions, see operator's manual.
G
To protect the pump from damage caused by freezing, read
the operator's manual for winter or long term storage.
Have Questions?
Do not return to store. We can help.
Call Customer Service Toll-Free 1-800-743-4115
or visit our website BRIGGSandSTRATTON.COM
8
8
9
10
13
11
12
14
The indicator
15
16
14
13
13
14
13
15
8
K
H
J
9
M N
10
P
M
11
Q R
12
S
T
13
U
V
14
W
15
16
Z
Y
X