Publicidad
OPERATING INSTRUCTIONS
HEATER OPERATION
Always operate the heater in the upright position following all instructions and
recommendations listed in this manual.
HEATER LOCATION
Place the heater in the area of the room that is coldest.
HEATER CONNECTION
outlet. A loose connection may cause overheating and damage to the plug or heater.
NOTE: To prevent overloading a
circuit, do not plug the heater into a circuit that is
servicing other electrical needs.
TURNING THE HEATER ON
ff
Level Control from the OFF position
to the
or
setting.
largest
(During initial heater use, you
" "
may experience a slight odor or smoking. This is
the result of the heating element lubrication
ff
away after a few minutes of use.)
POWER LEVEL CONTROL
This heater has two heat settings:
and
(1500 watt) to raise the room temperature quickly.
comfortable temperature.
SETTING THERMOSTAT
After heater has been turned on and the
ff
maintain this temperature.
TURNING OFF
To discontinue use, turn the Power Switch to the O position. Always turn the heater
OFF before unplugging or plugging in the heater. Heater should be unplugged when
not in use.
OSCILLATION CONTROL
You can control the Oscillation feature on the Fan Heater by moving the Oscillation
switch located on the heater base to the
or O position. In the
heater body will swing slowly back and forth.
6
f
Fig. 2
. Use the higher setting
ffi
has reached the desired temperature,
the largest " "
Oscillation
Control
setting the
OPERATING INSTRUCTIONS
TO OPERATE FAN ONLY
will function while in fan mode.
IMPORTANT SAFETY FEATURES
The power indicator light, located above the control panel, lights whenever the heater/
fan is plugged in to tell you that the heater has power. The heater is equipped with an
automatic overheat protection device located inside the body of the heater. If the
heater grill is obstructed, or if the heater gets too hot for any reason, the automatic
also equipped with a safety tip-over switch to turn
simply stand heater upright. With tip over
protection, the heater will only operate when placed upright on a level surface.
CARE AND MAINTENANCE
CLEANING
CAUTION:
Before cleaning the heater be sure to disconnect power cord and allow
the heater to cool completely.
CAUTION:
REPAIR
Do not attempt to open the heater to clean or otherwise service the inside. If the heater
does not function normally, call the following customer assistance number to arrange
for possible heater service and repair: 1-866-877-1889
STORAGE
Keep original carton for storage of the Fan Heater . Coil and tie the power cord to
7
Oscillation
The heater is
Publicidad
