Publicidad
Idiomas disponibles
Idiomas disponibles
BRAKE CONTROL HARNESS:
• Determine a suitable mounting point on the tow vehicle for the Electric Brake
Control Harness.
Note: Brake Control not included. Brake Control Harness designed to work with Tekonsha®
Brake Controls such as: 90195, 90885 or 90160. Go to www.tekonsha.com for more details
or where to buy.
• Route the Brake Control Harness' White/Blue/Black wires through an existing grommet on
the fire wall and into the engine compartment. Route wires through grommet by creating
a small hole in the grommet to pass the wires through.
• Route the Brake Control Harness' white wire to existing vehicle chassis ground point.
Using provided ring terminal, mount.
• Route the Brake Control Harness' Black wire to vehicle's positive post underneath hood.
Using 30 amp fuse holder (Brake Control), butt connector, and ring terminal, connect.
• Route Blue wire (Electric Brake Output) to Body Harness Blue wire. Using butt connector,
connect blue wires.
• Using the supplied convoluted tubing, cover the Blue/Black (and partially cover the white)
wires from the grommet to the fuse holder.
• Route the red wire to the cold side switch of the brake pedal. Connect using supplied
wire tap or the best suited alternative.
• When using a volt meter or circuit tester, carefully probe one wire at a time.
CAUTION Do not probe across two wires or across vehicle structure.
CAUTION When splicing use appropriate gauge wire splices. Provided blue tap are for
16-18 gauge wire only.
• Secure the brake harness connector near desired Brake control mounting location.
7-WAY HARNESS:
• Determine 7-Way mounting location.
• Route the 7-Way Harness containing the 7 wires behind rear bumper fascia and over
bumper support bracket, towards the Mounting location.
COMPLETION:
• Secure harness with the cable ties provided, to prevent damage or rattling. Be careful to
avoid any areas that would pinch, cut or melt the wire.
• Apply heat directly to butt connectors, working from the center out to the edges, using a
hot air gun or other source, until the tubing recovers and the adhesive flows. Allow to cool
before inspecting splice and checking integrity.
• Replace all coverings, grommets or any other components that were removed for ease of
installation. Some grommets will need to be altered to allow wires to pass through. Seal
altered grommets with silicone.
• Reconnect the vehicle's Negative (-) battery cable.
• Test and verify installation with a test light or trailer once installed.
TROUBLE SHOOTING GUIDE:
7-Way not function-
Ensure T-One® T-Connector ends are fully inserted and locked in
ing properly
place. Remove Tow Harness power Module 25 amp fuse for 10
seconds and repeat test.
No Power to 7-Way
Installation may have activated circuit protection. Start vehicle and
turn all functions off: Tail (head lights), brake and turns. Remove Tow
Harness power Module 25 amp fuse for 10 seconds and repeat test.
Contact a Tekonsha® approved installer for a professional installation! http://www.tekonsha.com
STILL HAVING TROUBLES?
Just enter you zip code in Where to buy.
• Using wire insertion detail, pin 7-Way Connector.
• Connect 7-Way connector and 7-Way socket. Mount 7-Way (Bracket not included).
Check chassis grounds. Ensure ring terminals are in full contact with vehicle's chassis. Remove
Tow Harness power Module 25 amp fuse for 10 seconds and repeat test.
Ensure 25 amp fuse is fully inserted into fuse holder. Fuse should have no breaks. Fuse holder
connected properly to positive post of battery. Remove 25 amp fuse for 10 seconds and
repeat test. Ensure module is connected to B+. Using a tester or volt meter check for voltage
on either side of the yellow butt connector near the module. Remove Tow Harness power
Module 25 amp fuse for 10 seconds and repeat test.
Page 3
FRANÇAIS •
ESPAÑOL
APERÇU DE LA QUINCAILLERIE / REPASO DE LAS PIEZAS:
Cosse à anneau (4)
Ruban double-face (1)
Porte-fusibl (3)
Terminal de anillo (4)
Cinta de dos caras (1)
Portador de fusibles (3)
Attache de câble, 8.5 po (24)
Attache de câble, 14.5 po (1)
Amarre de cable 8.5" (24)
Amarre de cable 14.5" (1)
OUTILS REQUIS / HERRAMIENTAS NECESSARIAS:
Tournevis Phillips #2
Destornillador de estrella (Philips) #2
Soufflerie d'air chaud
Outils à dénuder/Sertisseurs
Soplador de aire caliente
Pelacables/ Plegadores de cable
MODULITE®
T-ONE® CONECTOR EN T /
MODULE®
T-ONE® CONNECTEUR EN T
MÓDULO®
MISE À LA TERRE DU CHÂSSIS
CONECTOR A TIERRA DEL
CHASIS
CABLES AMARILLO/MARRÓN/ZUL
FILS VERT/ROUGE
FAISCEAU DE CARROSSERIE
CABLES VERDE/ROJO
ARNÉS DE LA CARROCERÍA
T-ONE®
CONECTOR EN T
T-ONE®
CONNECTEUR EN T
BRANCHER SUR LE FEU COMBINÉ
ARRIÈRE CÔTÉ PASSAGER
CONECTAR A LA LUZ TRASERA
DE COMBINACIÓN DEL LADO
DEL PASAJERO
JAUNE/AMARILLO
MARCHE ARRIÈRE/REVERSA
VERT/VERDE
ROUGE/ROJO
ARRIÈRE/TRASERAS
GAUCHE / ARRÊT
IZQ. / FRENO
7 VOIES CONNECTEUR
NOIR/NEGRO
BLANC/BLANCO
BATTERIE +12 V/VERDE
TERRE/TIERRA
7 VÍAS CONECTOR
BATERÍA DE +12V
BRUN/ MARRÓN
BLEU/AZUL
DROIT / ARRÊT
FREINS DE REMORQUE
DER. / FRENO
FRENOS DEL REMOLQUE
CÔTÉ D'INSERTION DU FIL / LADO DE INSERCIÓN DEL CABLE
www.cequentgroup.com
Technical Assistance: 800-632-3290
Fusible 25 ampères (1), Fusible 30 ampères (2)
Prise de fils (1)
Fusible de 25 amperios (1), Fusible de 30 amperios (2)
Toma de derivación(1)
Connecteur d'about jaune (4)
Conector de culata amarilla (4)
Coupe-fils
Extracteur de panneau de garnissage
Cortadores de cable
Retractor de paneles
Clé à cliquet
Douille 10 mm
Trinquete
Llave de 10 mm
BRANCHER SUR L'INTERRUPTEUR CÔTÉ FROID DE LA PÉDALE DE FREIN
CONECTAR AL INTERRUPTOR DEL LADO FRÍO DEL PEDAL DEL FRENO
MISE À LA
TERRE DU
CHÂSSIS
CONECTOR
A TIERRA
DEL CHASIS
BRANCHER SUR LE FEU COMBINÉ ARRIÈRE
CÔTÉ CONDUCTEUR
FILS JAUNE/BRUN/BLEU
BLEU
CONECTAR A LA LUZ TRASERA DE
COMBINACIÓN DEL LADO DEL CONDUCTOR
AZUL
BLEU/AZUL
25 AMP
30 AMP
30 AMP
NOIR/NEGRO
25 A
30 A
30 A
ROUGE/ROJO
VERROU DE FIL
BLOQUEO DE CABLES
TOW HARNESS
7-WAY
BRAKE
POWER MODULE
HARNESS
CONTROL
POWER FUSE
POWER FUSE
POWER FUSE
25 AMP MAX
30 AMP MAX
30 AMP MAX
PRISE 7 VOIES
CONECTOR DE 7 VÍAS
Page 4
Tubulure contournée
Tubos convoluted
Multimètre ou Voltmètre
Probador o Voltímetro
BLEU/ AZUL
PRISE DE FILS/
TOMA DE DERIVACIÓN
BLANC
ROUGE
BLANCO
ROJO
NOIR
NEGRO
FAISCEAU DE
COMMANDE DE
FREINS /
ARNÉS DEL
CONTROL DEL
FRENO
©2016 Cequent™ Performance Products
Publicidad
