Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Contents / Inhalt / Contenu / Contenido
Contents
Page 3-22
Inhalt
Seite 23-42
7.
Page 83+84
Permissible temperature ranges depending on electrical connections
2
WIKA Operating instructions/Betriebsanleitung/Mode d'emploi/Instrucciones de servicio
GB
D
GB
Contenu
Page 43-63
7.
Contenido Paginás 64-82
D
7.
E
F
1. Important details for your information
1. Important details for your information
F
Read these operating instructions before installing and starting the pressure transmitter. Keep
the operating instructions in a place that is accessible to all users at any time.
The following installation and operating instructions have been compiled by us with great care
but it is not feasible to take all possible applications into consideration. These installation and
operation instructions should meet the needs of most pressure measurement applications. If
questions remain regarding a specific application, you can obtain further information:
Via our Internet address www.wika.de / www.wika.com
„
The product data sheet is designated as PE 81.50, PE 81.51, PE 81.52
„
Contact WIKA for additional technical support (+49) 9372 / 132-295
„
If the serial number on the product label and/or the 2D code on the hexagon gets illegible (e.g.
by mechanical damage or repainting), the retraceability of the instrument is not possible any
more.
WIKA pressure transmitters are carefully designed and manufactured using state-of-the-art
technology. Every component undergoes strict quality and environmental inspection before
E
assembly and each instrument is fully tested prior to shipment. Our environmental manage-
ment system is certified to DIN EN ISO 14001.
Use of the product in accordance with the intended use IS-2X-S, IS-2X-F, IS-20-H:
Use the intrinsically safe pressure transmitter to transform the pressure into an electrical
signal in hazardous areas.
Certificate ATEX:
Pressure transmitter for operation in hazardous areas in compliance with the respective certifi-
cate (see attached EC-type examination certificate BVS 04 ATEX E 068 X).
ATEX Approval ratings:
Gases and mist: Mounting to Zone 0; Installation in Zone 0, Zone 1 and Zone 2.
Dust: Mounting to Zone 20; Installation in Zone 20, Zone 21 and Zone 22.
Mining Category M1, M2.
Certificate FM/CSA:
Pressure transmitter for operation in hazardous areas in compliance with the respective certifi-
cate (see Control drawing No. 2323880).
IS-2X
WIKA Operating instructions/Betriebsanleitung/Mode d'emploi/Instrucciones de servicio
GB
3
IS-2X
Publicidad
Tabla de contenido
