Tabla de contenido
Publicidad
26
CLARITY M/CLARITY M STEREO
CLARITY M/CLARITY M STEREO Getting started
Getting Started
(EN)
Mount the included stand:
• •
Remove the 2 hex screws
that hold the stand flat against
the back of the unit. The screws
are designed to be operated with
a 2.5 mm hex key, but you can also
use a T10 Torx driver or a 3/32 SAE
hex key if care is taken not to strip
the screw.
• • Flip the stand around so that it sticks
outward from the unit. The stand
has rubber pads to prevent it from
scratching the surface where it is
placed.
• • Replace the screws into the same
holes to secure the stand.
Connect the unit to AC power.
Use a standard TOS cable (not
included) to connect an
external digital audio device.
Use the SUB-D-15 cable
(included) to connect an
external digital audio device.
Hold the far right button to
switch the unit on.
Plug-in Metering
a. Download the CLARITY M
plug-in installer from
tcelectronic.com/
clarity-m/support.
b. Follow the installation instructions.
c. Connect the unit to your computer
via USB.
d. In your DAW software, insert the
CLARITY M plug-in at the place you
wish to monitor.
This can be a normal track, a bus,
an aux-bus or a master output.
e. In CLARITY M, go to the System (SYS)
menu and set USB Mode to "Plug-in".
In the unit, use the System
menu > Inputs to select the
appropriate input.
Use System > Preset Folder to
set your region for appropriate
loudness standards.
Use Library (Lib) to select an
appropriate preset and
press EXIT.
Use the RTA/RADAR/VSCOPE
switch to toggle between
Radar, RTA and Vector Scope.
Note – a full manual is available as a PDF,
download at https://www.tcelectronic.com/
tcelectronic/product?modelCode=P0D9L and
https://www.tcelectronic.com/tcelectronic/
product?modelCode=P0DC8
Publicidad
Tabla de contenido
