Technical Data - Beta 3065/20-10T Instrucciones

INSTRUCTIONS FOR USE ISTRUZIONI PER L'USO
AIR HYDRAULIC JACK USE AND CARE
• Place the jack so that the load is centred over it, at such gripping points as stated by the vehicle
manufacturer.
• If any extensions are needed, only use those supplied by the manufacturer with the jack. Do not use
the extensions without the plate. Do not use more than two extensions.
• Do not force the pressure relief valve that has the guarantee seal.
• Do not leave any pressure in the jack at end of stroke when there is no load.
• Before lowering the load, check that the handle is in the horizontal position.
• Store the jack in a suitable place when not in use.
• It is absolutely forbidden to make any structural changes to the jack, as these might affect its safety
characteristics.
PERSONAL PROTECTIVE EQUIPMENT TO WEAR WHILE USING AIR HYDRAULIC JACK
Failure to observe the following warnings may result in physical injury and/or disease.
ALWAYS WEAR SAFETY FOOTWEAR WITH PROTECTIVE TOE CAPS
ALWAYS WEAR MECHANICALLY RESISTANT PROTECTIVE GLOVES
The above-mentioned personal protective equipment refers to the use of the jack in normal
working environments. If any hazardous situations are shown following specific surveys,
it must be supplemented with such equipment as described in the risk assessment
document, in compliance with current standards concerning safety in the workplace.

TECHNICAL DATA

MAXIMUM CAPACITY
POWER SUPPLY PRESSURE
MAXIMUM AIR CONSUMPTION
AIR INLET
MINIMUM INTERNAL HOSE SIZE (ø)
MAXIMUM STROKE
MINIMUM HEIGHT
NUMBER OF PISTONS
PISTONS STROKE
OPERATING TEMPERATURE
WEIGHT
SOUND PRESSURE LEVEL
10 - 20t
8.0 ÷ 10 bar
400 nl/min
1/4" GAS, cone-shaped
6 mm
166 mm
140 mm
2
80 – 86 mm
-20 °C ÷ +50 °C
17.6 kg
60 dBA
EN I
9