Publicidad
Idiomas disponibles
Idiomas disponibles
STEP-BY-STEP ASSEMBLY
Step 12
With help, move the assembled Bookcase into its desired location. Secure the Bookcase to the wall by using the
included No-Tip Kit
. Locate a wall stud behind the Bookcase. Position one of the brackets on a stud approximately 1"
3
below the top of the Bookcase. Mark and drill a pilot hole into the center of the stud with a 3/32" drill bit. Attach one of
the brackets to the stud with the provided long screw. (PLEASE NOTE: If a stud is not in the desired location to attach
the bracket on the wall, you can use the provided plastic wall anchor. To do this, mark and drill a 1/4" pilot hole into the
dry wall. Insert a plastic wall anchor into the pre-drilled hole until the anchor is ush with the wall surface. Attach the
bracket to the plastic wall anchor with the provided long screw.) Next, mark the back of the Top Panel
with the same
A
alignment as the bracket attached to the wall. Temporarily, move the Bookcase away from the wall to accesss the back
of the Top Panel
. Place another bracket on the mark and pre-drill a 3/32" hole in the Top Panel
. Attach the bracket
A
A
to the Bookcase with the provided short screw. With help, move the Bookcase back into its nal position, taking care to
line up the wall bracket and the Top Panel
bracket. Thread a nylon strap through the holes in the brackets and
A
tighten the strap until snug. Do not over tighten. (IF necessary, a second No-Tip Kit
can be installed for added
3
security.)
3
No-Tip Kit
1pc
15/16
Publicidad
