PROZIS Hydrus Manual Del Usuario página 8

EN
How to use
1
4
1. Insert the nozzle into the hole at the top of the handle. If the nozzle needs to be replaced,
switch off the device and then press the release button to easily replace it.
2. Pour some water into the tank. There are two ways to fill the device with water:
• Open the tank cover, hold the device horizontally, pour some water into the tank and then
replace the tank cover.
• Remove the water tank, hold the tank vertically and fill it with water.
3. The device has three modes: Daily; High; Pulse.
Daily: Continuous water spray - first indicator light (2 minutes). Low water pressure is suited
for first-time users and sensitive people.
High: Continuous water spray - second indicator light (2 minutes). Regular use.
Pulse: Water is sprayed three times per second - third indicator light (2 minutes). The pulse
flow is for deep cleaning and massaging gums.
• In standby mode, press the button to switch between modes.
• If no mode is chosen for 3 seconds, the device will resume standby.
• If you're using the device for the first time please try the Daily mode for a week until you
have fully adjusted.
4. Before use, hold it vertically, with the nozzle turned towards your mouth and directed at
your teeth or gums. At the same time, slightly open your mouth so that water can flow out
smoothly.
14
2 3
5
5. Please note:
• Align the nozzle with the gumline and use it perpendicular to the gum.
• It cleans teeth, trays, crowns and dentures thoroughly.
• Do not spray water directly down the periodontal pockets.
• After use, press the power button to switch it off.
• This product has a 2-minute timing function. If you still need to use it, just press the power
button again to switch it on.
• It features a memory function mode.
6. Installing the tips
• Press and hold the key at the back of the unit to install a tip that is right for you. Click the tip
into place.
Classic Jet Tip
This tip can be used every day for a deeper cleaning between teeth and below the gumline
where regular flossing and brushing cannot reach.
Disassembly and Disposal
1 2
1
2
NOTE: This process is not reversible.
Do not disassemble the product by yourself. This operation requires basic safety precautions.
• Before removing the battery, you must unplug the power plug and the charging plug.
• Before removing the battery, make sure it is depleted. If you need for it to run out of power,
you can press the power button to switch on the device and allow it to work until it stops
automatically.
• Press the nozzle release button (Figure 1 -
tank in the direction of the arrow (Figure 1 -
• Remove the main body back cover in the direction of the arrow (Figure 2).
• Use an appropriate screwdriver to unscrew the four screws and remove the movement
assembly (Figure 3).
Troubleshooting
Some issues that arise may be solved by the user. If the problem persists after having tried
the following solutions, please contact Prozis customer service.
3
) to remove the nozzle, and move the water
1
).
2
EN
15