Statistics; Setting The Tone; Programming Coffee; Programming Cappuccino - Bauknecht KMT 9145 PT Instrucciones Para El Uso

Statistics

This function enables you to view the machine statistics. To view them, proceed as follows:
• Press the MENU button (B2) to access the menu and then buttons
message STATISTICS.
• Press OK (B7).
• Press buttons (B5) and (B6) to verify:
- how many coffees and cappuccinos have been made;
- how many times the machine has been descaled;
- the total number of litres of water run off.
• Press the MENU button (B2) once to exit the function, or press MENU (B2) twice to exit the menu.

Setting the tone

This function enables you to activate or deactivate an acoustic signal emitted by the machine each time a button is pressed and
each time the accessories are inserted/removed.
N.B.: the machine is factory set with the acoustic signal activated.
• Press the MENU button (B2) to access the menu and then buttons
SET TONE ACTIVATED.
Press OK (B7). The display shows the message SET TONE DEACTIVATE?.
•
• Press OK (B7) to deactivate the acoustic signal.
• Press the MENU button (B2) to exit the menu.

Programming coffee

For instructions on programming coffee, refer to chapter CHANGING THE AMOUNT OF COFFEE IN THE CUP.

Programming cappuccino

For instructions on programming cappuccino, see chapter CHANGING THE AMOUNT OF MILK AND COFFEE FOR CAPPUCCINO.

Programming water

For instructions, refer to chapter CHANGING THE AMOUNT OF HOT WATER.

CLEANING AND MAINTENANCE

Cleaning the machine

Do not use solvents or abrasive detergents to clean the machine. A soft damp cloth will suffice. The following machine parts
must be cleaned regularly:
• Coffee grounds container (A4).
• Drip tray (A14).
• Water tank (A12).
• Coffee spouts (A13).
• Feed funnel for adding pre-ground coffee (A21).
• The inside of the machine, accessed from the service door (A2).
• The brewing unit (A5).

Cleaning the coffee grounds container

When the display shows the message EMPTY WASTE COFFEE CONTAINER!, empty and clean the grounds container. To clean,
proceed as follows:
• Open the service door on the front of the machine (Figure 16), next remove the drip tray (Figure 17), and clean it.
• Clean the coffee grounds container thoroughly.
N.B.: When removing the drip tray, the grounds container MUST be emptied.

Cleaning the drip tray

WARNING
The drip tray has a water level indicator in the form of a red float (Figure 27).
Empty and clean the drip tray before the red float protrudes from the cup tray.
To remove the drip tray:
1. Open the service door (Figure 16).
2. Remove the drip tray and the coffee grounds container (Figure 17).
3. Clean the drip tray and the grounds container (A4).
4. Fit the drip tray and the coffee grounds container back in place (A4).
5. Close the service door.

Cleaning the water tank

1. Clean the water tank (A12) regularly (about once a month) with a damp cloth and a little mild detergent.
2. Take care to remove all traces of detergent.
If the drip tray is not emptied, the water can overflow. This can damage the machine.
(B5) and (B6) until the machine shows the
(B5) and (B6) until the display shows the message
GB36