Disposal; Assistance And Warranty - Imetec INTELLIVAPOR ECO E9801 Instrucciones Para El Uso

The steam (ready) LED (9) does
not light up or water leaks from the
boiler cleaning cap (4).
Patches remain wet while ironing.
The iron does not stay up
in vertical position.
Pursuant to Art. 26 of Italian Legislative Decree no. 49 of 14 March 2014 "Implementation
of Directive 2012/19/EU on waste electrical and electronic equipment (wEEE)", the
crossed bin symbol on the appliance or its packaging indicates that the product must
be disposed of separately from other waste at the end of its useful life.
The user must therefore take the appliance to an appropriate recycling centre for
electrical and electronic equipment.
Alternatively, instead of handling the disposal, the appliance can be handed over to
the retailer when a new, equivalent appliance is purchased.
Retailers of electronic products having a sales area of at least 400 m2 can also be
handed electronic products that are to be disposed of measuring less than 25 cm,
free of charge and with no obligation to buy.
Appropriate separate collection for the subsequent procedure for the decommissioned
appliance for recycling, which includes treatment and environmentally friendly
disposal helps prevent adverse effects on the environment and health and promotes
reusing and/or recycling materials that the appliance consists of.
The appliance is guaranteed for a period of 2 years from the date of purchase. Evidence
shall be constituted by the date indicated on the receipt/invoice (provided it is legible),
unless the buyer can prove that the delivery occurred later.
In the case of a defective product existing prior to the date of delivery, IMETEC guarantees to
repair or replace the appliance at no cost, unless one of the two solutions is disproportionate
to the other. The buyer has the obligation to notify an IMETEC Service Centre of the non-
conformity within two months after discovering the defect.
The warranty does not cover any part that may be defective due to:
a. transport damage or accidental drops,
b. incorrect installation or an inadequate electrical system,
c. repairs or alterations made by unauthorised personnel,
d. poor or incorrect maintenance and cleaning,
e. product and/or product parts subject to wear and/or consumables,
f. failure to comply with the operating instructions and/or negligent or careless use,
g. the water used is different from that described in the manual,
h. thinner, scented liquids or descaling agents are used,
i. plate damage caused by ironing unsuitable fabrics or with inadequate temperatures
for the fabric.
The cleaning cap (4) has not been
tightened properly.
Sometimes patches remain wet after being
steam ironed as the steam condenses on
the ironing board.
The iron has been designed to be set
horizontally.

DISPOSAL

ASSISTANCE AND WARRANTY

Make sure the cleaning cap is tightened well.
Pass the iron a number of times on the wet
patches without dispensing steam. If the lower
part of the ironing board is wet, dry it with a
dry cloth.
Use a mesh ironing board to prevent the steam
from condensing on the ironing board.
Place the iron on the heat resistant mat (12).
EN
17