Panasonic ES8096 Instrucciones De Operación página 7

the rechargeable batteries for the
purpose of proper disposal.
1. Slide the trimmer handle up until
it clicks in.
2. Remove the screw (a) and the
panel cover (b).
3. Remove the two screw covers (c)
(using something like a tooth-
pick), and 6 screws (d).
4. Remove the back panel (e).
5. Lift the battery block (f) and re-
move it from the battery terminal
sealing (g).
6. Remove the batteries from the
battery block (h).
WARNING:
Do not attempt to replace the bat-
teries for the purpose of reusing
the shaver. This could result in the
risk of fire or electric shock.
Caution
• Do not charge the shaver where the
temperature is below 0°C (32°F) or
above 40°C (104°F), where it will
be exposed to direct sunlight or a
heat source, or where there is a lot
of moisture.
• Use only the included shaver
charging adaptor RE7-01 to charge
the ES8096/ES8097 shaver.
• The supply cord of the charging
adaptor cannot be replaced; if the
cord is damaged, the entire charger
should be discarded.
• Dry the shaver completely before
setting it in the charging adaptor.
• Keep the charging adaptor away
from water and handle it only with
dry hands. Do not use an extension
cord to connect the charging adap-
tor to an outlet.
• The shaver may not immediately
begin to charge after being placed
into the charging adaptor after use.
Allow the shaver to sit in the charg-
ing adaptor for a few minutes and
check again to make sure that it is
being charged.
• Do not place any metal objects like
coins and paper clips on the charg-
ing adaptor as they will become
warm.
• Grip the plug when disconnecting
the charging adaptor from a recep-
tacle; tugging on the cord may dam-
age it.
• Store the charging adaptor and its
cord set in a dry area where it will
be protected from damage.
• The linear motor of the shaver may
start operating without the On/Off
switch on if the shaver is placed
near a television, stereo, audio-
visual equipment or anything that
generates strong magnetic field.
Do not place the shaver near these
equipments.
• The outer foil is very thin. If han-
dled improperly, it can be easily
damaged. To avoid personal injury,
do not use the shaver if it has a
damaged foil or inner blade.
• Wash the shaver in tap water. Do
not use salt water or boiling water.
Also, do not use cleaning products
that are designed for toilets, bath-
rooms or kitchen appliances. Do
not submerge the shaver for a long
time.
• Do not wipe any part of the shaver
with thinner, benzine or alcohol.
10
10
Clean it by using a cloth dampened
with soapy water.
• Do not take the housing apart as
this can affect the watertight con-
struction.
• Do not shave when the "sonic" vi-
bration is activated, as it may dam-
age your skin.
Specifications
Power source: 100-240V AC,
50-60 Hz (Automatic voltage conver-
sion)
Motor voltage: 2.4 V DC
Charging time: 1 hour
This product is intended for house-
hold use only.
READ ALL INSTRUCTIONS BE-
FORE USE.
FOR YOUR CONVENIENCE, WE HAVE ESTABLISHED A TOLL-FREE
(IN USA ONLY) NATIONAL ACCESSORY PURCHASE HOT LINE AT
1-800-338-0552.
FOR CANADA, PLEASE CONTACT ONE OF THE SALES BRANCHES
MENTIONED ON THE BACK PAGE.
11
11