Haldex Pure Air Plus DQ6032 Instrucciones De Instalación

Installation
Guide
L31146 Rev. 2/02
Pure Air Plus™
Coalescing Filter Kit
(DQ6032)
DQ6032 COALESCING FILTER KIT
INSTALLATION INSTRUCTIONS
!
WARNING
When working on air system components the following precautions
should be observed.
1. Stop engine when working under a vehicle. Always block the
vehicle wheels to prevent a fore or aft roll. Bleeding off system
pressure may cause the vehicle to roll. Keep hands away from
brake chamber push rods and brake adjusters; they may apply
as system pressure drops.
2. Never connect or disconnect a hose or line containing air
pressure. It may whip as air escapes. Never remove a
component or a pipe plug unless you are certain all system
air pressure has been exhausted.
3. Never exceed recommended working air pressure and always
wear safety glasses when working with air pressure. Never
look directly into component ports or direct a pressurized air
flow at anyone.
4. Never attempt to disassemble a component until you have
read and understood all recommended procedures. Some
components contain powerful springs and injury can result if
not properly disassembled. Use only proper tools and observe
all precautions pertaining to the use of those tools.
KIT CONTENTS
The DQ6032 Coalescing Filter Kit contains One Each: O-Ring,
Coalescing Filter and Desiccant Canister Gasket. Be sure to read
Service Instruction #5 before you begin servicing your Air
Dryer. Careful removal of the desiccant canister is required as the
desiccant canister will be put back on the Pure Air Plus Air Dryer
after servicing.