Safety Guidelines - Hoover ONE PWR BH90200 Manual Del Usuario

5� Carefully pour the liquid into the tank� Rinse the measuring cap with clean water�
6� Screw the measuring cap back onto the sprayer, making sure it is tightened securely�
7� Reinstall the battery pack�
NOTE: If using a measuring container other than the measuring cap, or if using a funnel
to fill the tank, be sure to thoroughly clean and rinse these items after use� If premixing
the spray solution, rinse the container used for mixing�
NOTICE: It is important to thoroughly clean the unit after each use. Allowing liquid to
remain in an idle tool for an extended period may cause its moving pieces and connectors
to seize up.
Connecting the Battery Pack
WARNING:
Always remove battery pack from your tool when you are
assembling parts, making adjustments, cleaning, or when not in use. Removing battery
pack will prevent accidental starting that could cause serious personal injury.
TO INSTALL:
1� Align the raised rib on the battery pack with groove in the battery port and place the
battery pack in the tool�
2� Make sure the latches on each side of the battery pack snap in place and that the
battery pack is secured in the tool before beginning operation
TO REMOVE:
1� Depress the latches on both sides of the battery pack to release the battery pack and
remove it from the tool�
For complete charging instructions, see the operator's manuals for your battery pack and
charger�
WARNING:
Risk of fire or explosion. Spray area must be well ventilated and
away from sparks or flames.
WARNING:
DO NOT use on or near electronic devices.
Turn the Sprayer ON/OFF
1� To turn the sprayer ON, depress the ON/OFF
button�
2� To start the flow of liquid at the spray wand,
depress the trigger�
3� To stop the flow of liquid at the spray wand,
release the trigger�
4� To turn the sprayer OFF, depress the ON/OFF
button again�
LOCK-ON
1� To lock-on, depress the trigger and slide it
forward�
2� To release the lock-on, depress the trigger and slide it backward
NOTE: Make sure the trigger is not locked on before inserting the battery pack into
the sprayer�
How To Adjust The Nozzle
The spray nozzle can be adjusted
from a stream to a fan spray�
1� Remove the battery pack from
the tool�
2� Loosen the nozzle for a stream�
3� Tighten the nozzle for a fan
spray�
Using Your Sprayer
DANGER:
Improper application of cleaning solution can result in SEVERE
INJURY or DEATH. Follow CDC and EPA guidelines for cleaning. Follow the chemical
manufacturer's safety instructions and guidelines listed on the SDS sheet.
1� Install the battery pack into the tool�
2� Depress the ON/OFF button to start the motor�
3� Remove and hold the handle as shown�
4� Aim the sprayer nozzle directly at the objects you wish to spray�
NOTE: Make sure to stand far enough from the object being sprayed to prevent the spray
from splashing back onto you�
5� Depress the trigger to start the spray�
6� Release the trigger to stop the spray�
7� Always empty, clean, and drain the tank after every use as directed in the Maintenance
section�
8� Thoroughly clean the chemical sprayer before storing or before switching to a
different chemical� See Cleaning the Unit later in this manual�
9� When you are finished with the sprayer, thoroughly wash your hands and any area
where skin has been exposed to the spray

Safety Guidelines

• Never point the spray end of the sprayer at yourself or others.
• Avoid spraying on windy days. Mist can be accidentally blown onto objects that should
not be sprayed.
• Never point sprayer in the direction of people or animals; always direct downwind.
• Especially in warmer weather, use sprayer in the early morning or late afternoon.
Excessive heat can evaporate the mist before it settles.
• Never smoke, eat, or drink while operating the sprayer.
• Do not touch nozzle when sprayer is in operation.
5