Maintenance And Care; Spare Parts And Accessories - Flex CS 62 18.0-EC Instrucciones De Funcionamiento Originales

CS 62 18.0-EC
 The battery is fully charged when the
display
The green backlighting goes out after
a short time.
 Remove the battery from the charger.
 Pull out the mains plug.
NOTE
If the display flashes after the battery is
inserted in the charger, there is a fault in the
battery or in the charger.
Display flashes slowly.
Backlighting orange.
The battery is too hot or too cold. The charging
process starts when the battery reaches the
charging temperature (0°C...55°C).
Display flashes rapidly.
Backlighting red.
Remove the battery from the charger and
insert again. If the same display persists, the
battery is faulty. Replace the battery or have
it checked at an authorised repair shop.
If this error message is displayed again with
a different battery, this indicates that there
is a fault in the charger. Have the charger
checked at an authorised repair shop.

Maintenance and care

WARNING!
Remove the battery before carrying out any
work on the power tool.
appears.
Cleaning
Cleaning the electric power tool
WARNING!
Do not use water or liquid detergents.
 Regularly blow out the housing interior
and motor with dry compressed air.
 Clean saw bench and setting devices
using a vacuum cleaner and paint brush.
 Occasionally spray joints with machine oil.
 Also clean the guide rail, otherwise the
saw will not be guided properly resulting
in an inaccurate cut.
Charger
WARNING!
Before performing any work, pull out
the mains plug. Do not use water or liquid
detergents.
 Remove dirt and dust from the housing
with a brush or a dry cloth.
Repairs
Repairs may be carried out by an authorised
customer service centre only.
NOTE
During the warranty period do not loosen
the screws on the motor housing.
Non-compliance will deem the guarantee
obligations of the manufacturer null and void.

Spare parts and accessories

Other accessories, in particular insertion
tools, can be found in the manufacturer's
catalogues.
Exploded drawings and spare-part lists can
be found on our homepage:
www.flex-tools.com
25