Additional Operational Notes
Adjusting the Alert Volume
The Bendix
Fusion
system audible alerts are pre‑set at the factory for fully
®
™
integrated systems and cannot be turned off by the driver. Depending on the OE,
the volume may be adjustable. For systems using a Bendix
Driver Interface Unit
®
(DIU
) display, see Bendix Fusion Advanced FLR10
Sensor Service Data Sheet
™
™
SD-61-4962 for information about volume adjustment.
Event Capture
In the case of vehicles configured to do so, the enable/disable switch used
by the system also functions – when depressed for six seconds – to activate
a request from the SafetyDirect
by Bendix CVS Processor on the On‑Board
®
Computer (OBC)/telematics system to transmit ten seconds of video data –
the five seconds before and the five seconds after the button was pressed.
In some cases, more video data may be available using the SafetyDirect web
portal (subscription fee applies).
SafetyDirect by Bendix CVS delivers actionable information that can help
improve fleet and driver safety. Data from the Fusion system's brake sensors,
camera, and radar provides real-time knowledge and insight about your
vehicle and surroundings while on the road. Together with the SafetyDirect
Processor (SDP), they collect complex safety data and video that the SDP
transfers to the SafetyDirect web portal (safetydirectportal.com) for review.
The user-friendly SafetyDirect web portal captures that data then, using your
fleet's telematics system, automatically transmits driver performance and
event-based information – including video – to your back office for analysis.
Other Information
Federal Communications Commission (FCC) Part 15: These devices comply
with Part 15 of the FCC rules with the limits for a Class B digital device and
with RSS‑210 of Industry Canada. Operation is subject to the following two
conditions: (1) these devices may not cause harmful interference, and (2) these
devices must accept any interference received, including interference that
may cause undesired operation.
29