Installation; Procedure For Use - Schulz AIR Plus Spray Manual De Instrucciones

8. INSTALLATION

MODEL
Air Plus Spray Schulz
ELECTRIC SAFETY
Figure 8.1 shows the connection plug-inlet. For your safety against electric shock, only use your paint spray
in structures with residual differential circuit breaker (RD) of 30mA. If necessary, hire an electrician you trust and
ask for the installation of this safety component part.

9. PROCEDURE FOR USE

ATTENTION
area. - When using an electric product, certain basic safety precautions must be observed in order to reduce
risks of fire, electric shock and personal injury.
- Make sure the paint spray is turned off and disconnected from the energy inlet before starting the procedures
that follow the preparation for use.
- Accident danger! Never press the activation trigger during the adjustment of the paint regulator.
- Never point the gun in your direction, especially when it is energized.
Power
W
250 450 600 700
TABLE 8.1 – ELECTRIC INSTALLATION
FIGURE 8.1 – CONNECTION OF THE PLUG TO THE INLET
- Before using the paint spray, make sure there are no people or pets in the operating
0
45
30
Cable Fuse Circuit
Voltage
(Min. section) breaker
V mm² A
127
1,5 10
220
15
FIGURE 9.1
35
Maximum distance of Extension up to 10m
the distribution board (Minimun section)
metros mm²
10
1,5
30