Troubleshooting - Galletti AREO AC-P Manual Del Usuario

AREO ACP
8 MAINTENANCE
The routine maintenance operations to be performed on AREO ACP fan
heaters mainly concern the heat exchanger. It must be cleaned to eliminate
dust build-up, which tends to obstruct the spaces between the fins,
resulting in a decrease in the quantity of heat exchanged.
This job may be done using jets of compressed air.
If grease has also deposited you can wash the fins, taking care not to wet
the electric motor and making sure the finned block is thoroughly dried
before starting the fan heater.
It is recommended to carry out these operations at least once a year before
the start of the heating season.
The electric motor requires no maintenance as it is of the closed type with
self-lubricating bearings.
Every time you start up the unit after it has been off for a long time, make
sure no air is trapped in the heat exchanger.
Special care should be taken when carrying out maintenance work:
- some metal parts may cause injuries; wear protective gloves.
- maintenance may be performed exclusively by specialised personnel;
contact your dealer or installer.
- For safety reasons, before carrying out any maintenance or cleaning
jobs, turn off the main switch of the unit to disconnect the power supply.
- If any work needs to be done on a unit that is working with hot water,
it is advisable to shut off the hot water (by means of the on-off valves)
and allow the fan to run for a few minutes until all the metal parts have
cooled down before carrying out any job on the fan heater.
Stop the fan and disconnect the unit from the power supply before
working on it.
È severamente vietata la riproduzione anche parziale di questo manuale / All copying, even partial, of this manual is strictly forbidden
9

TROUBLESHOOTING

If the unit is not working properly, before calling a service engineer carry
out the checks indicated in the table below.
If the problem cannot be solved, contact the dealer or service centre.
Problem Cause
1 No power supply
The fan heater does
not work at all 2 The motor overload
cutout has tripped
3 The main switch is in
the off position
1 An obstacle is obstructing
the air intake or outlet
The fan heater 2 Air is trapped inside
provides inadequate the heat exchanger
heating 3 The operating speed
selected is too low (3-
speed model)
1 Operation in 4-pole air
conditioning mode
The fan heater "leaks" 2 Leaky plumbing
water. connections
3 Only heating
- Per contattare l'azienda, per qualsiasi informazione o
segnalazione: info@galletti.it
7
GB
Solution
1 Restore the power
supply
2 Contact the after-sales
service
3 Switch on the power
supply
1 Remove the obstacle
2 Contact the installer
3 Select a higher speed
1 Select a lower speed
2 Contact a service
centre or your installer
3 Only heating
AP66000756 - 02