Publicidad
Idiomas disponibles
Idiomas disponibles
Attention!
Risk of property damage
The pressure can also cause the product to
■
flow out and cause the device to stick strongly
together.
¾ Never completely shut the air regulator [2]
during use.
Setting compressed air consumption
Turn the air supply regulator [11]:
■
• Clockwise: Air flow reduces until it is completely
stopped.
• Anticlockwise: Airflow increases (higher con-
sumption).
Note
During normal use, the air supply regu-
lator [11] must be completely open if
the pressure is between 3–4 bar.
It must be adjusted if the pressure is
above 4 bar.
Combined setting
Combined setting of the nozzle regulator [8] and
the air regulator [2] allows a smooth or rough
surface to be achieved as desired; and thus a finish
matching the original finish of the part being treated
can be achieved.
Water-based products
Turn the nozzle regulator [8] clockwise to a
■
maximum 10–12 mm. The nozzle needle is fully
opened and consequently maximum product
flow from the tank is achieved.
Smooth surface setting
Completely open the air vent regulator [3] (turn
■
clockwise). During use air flows from the tank
(reducing the pressure available in the tank) and
reduces the product quantity.
If spraying is not taking place, slowly turn the air
■
vent regulator [3] anticlockwise until the desired
product quantity is achieved.
Fully open air regulator [2].
■
Set atomisation using air regulator [2].
■
16
Rough surface setting
Slightly close air vent regulator [3] (anticlock-
■
wise). As a result, the pressure in the tank
increases and with it the product quantity.
Slightly close air regulator [2] dependent on the
■
surface.
Set atomisation using air regulator [2].
■
Attention!
Risk of property damage
The pressure can also cause the product to
■
flow out and cause the device to stick strongly
together.
¾ Never completely shut the air regulator [2]
during use.
Combined setting
Combined setting of air vent regulator [3] and air
regulator [2] allows a smooth or rough surface to
be achieved as desired; and thus a finish matching
the original finish of the part being treated can be
achieved.
The air supply regulator [11] is in these cases set to
match the requirements of the operator.
Publicidad
