Metal Bracket; Glue - Sauder Cannery Bridge 416082 Manual De Usuario

Step 9
Fasten two METAL BRACKETS (4G) to the BACK SKIRT (N). Use two BLACK 9/16" LARGE HEAD SCREWS (1S).
å
NOTE: Be sure the BRACKETS are even with the edges of the BACK SKIRT.
å
Fill the holes in the BACK SKIRT (N) 1/4 to 1/2 full with GLUE (54M). Then, insert two WOOD DOWELS (15F) into the
å
holes. Wipe away the excess GLUE.
Now, fi ll the hole in the LEFT REAR LEG (L) 1/4 to 1/2 full with GLUE. Then, insert the WOOD DOWEL in the BACK SKIRT
å
into this hole. Wipe away the excess GLUE.
NOTE: Be sure the CAM SCREWS in the LEG insert into the holes in the BACK SKIRT. You will not tighten these HIDDEN
å
CAMS at this time.
Fasten the BACK SKIRT (N) to the BOTTOM (E2). Use two BLACK 9/16" LARGE HEAD SCREWS (1S) through the METAL
å
BRACKETS on the BACK SKIRT and into the BOTTOM.
Caution
!
Inspect the parts thoroughly before
assembling. Disassembly of glued
parts is extremely diffi cult.
BLACK 9/16" LARGE HEAD SCREW
(4 used for the METAL BRACKETS)
www.sauder.com/services
54M
B
1S
N
15F
L
416082
4G
E2
N
Edge without
METAL BRACKETS
Page 13