AKASO EK7000 Manual Del Usuario página 11

PHOTO
To capture a photo, verify the camera is in Photo mode.
To take a photo:
Press the Red Photo Button. The camera will emit a camera shutter sound.
BURST PHOTO
To capture a Burst Photo series, verify the camera is in Burst Photo mode.
To take a Burst Photo series:
Press the Red Photo Button. The camera will emit a camera shutter sound.
TIME LAPSE
To capture a Time Lapse series, verify the Continuous Lapse is ON and camera is in
Time Lapse Mode.
To take Tome Lapse:
Press the Red Photo Button. The camera initiates countdown and emits a camera shutter
sound each time a Photo is taken.
CR2032 BATTERY REPLACEMENT FOR EK7000 REMOTE
1. Use a 1.8mm Phillips tip screwdriver to remove the 4 screws on the back cover of the
remote, allowing you to open it.
17
2. Remove another 4 screws on PCB board.
3. Lift the PCB board and slide out the battery, as shown in the picture.
Note: Do NOT rotate the PCB board to avoid reversing the camera and video button functions.
4. Install the new battery, keeping the "+" pole facing up.
5. Install all 4 screws back onto the PCB board.
6. Install all 4 screws back into the cover.
18