Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
4. Shoulder straps are pre-attached to sprayer with a
buckle. Attach lower end of straps by fastening strap
hooks to metal frame between where frame exits
plastic tank and where frame makes a bend.
(See Figure 5)
7
1
3
2
8
Flat Spray
Nozzle
1.
Mix spray formula and proper volume of water in
a separate container. Pour the mix through filter
basket in the tank opening. This keeps debris from
entering the sprayer.
2. Pump sprayer handle to prime the pump and
pressurize the pressure cylinder. The volume of liquid
in sprayer tank will appear to decrease as the
pressure cylinder is pressurized.
NOTE: Completely filling sprayer tank each
time is not necessary. Mix only the amount
needed to complete job.
PAGE 2 OF 12
ASSEMBLY CONTINUED
SPRAY TIP ASSEMBLY
7
7
4
3
2
2
8
8
Hollow Cone
Jet Stream
Spray Nozzle
Spray Nozzle
Figure 5
Strap
Hook
5
7
6
2
8
Plastic Adjustable
Spray Nozzle
OPERATION
3. In a safe area, point wand upward and press the
shut-off valve lever, spraying for 10 seconds or until
no air and only liquid is coming out. This will bleed
all air out of hose and wand.
4. Press and hold hand lever to open valve and spray.
NOTE: Should pressure drop very quickly, drain
tank completely and pump without liquid. By
this procedure, air chamber is refilled with the
required volume of air. It is advisable to pump
the tank completely empty from time to time.
REF.
DESCRIPTION
1
Flat Spray Nozzle
2
Filter
3
Jet Cap
4
Swirl Plate
5
Nozzle Cap
6
Nozzle Body
7
Nozzle Retaining Nut
8
Elbow
1220 IH-7986
Publicidad
Tabla de contenido
