Tecknet HWD01161 Manual Del Usuario página 3

To Change the Chime
This can be done before or after pairing
1. Plug in the receiver, there would be a chime prompt.
2. Simply press Music + or Music – to play through the different chimes included in
the receiver.
3. Once you have found the chime you like simply let it play.
A. If your transmitter is paired, the next time it is pressed it will play your
selected chime.
B. If it doesn't however, please follow the instructions for deleting the pair.
Choose your chime again and then re-pair as instructed above.
To pair the device
1. Plug in the receiver.
2. Press the Music + (the top button) and the volume buttons (central circle) together,
the LED will light up.
3. Then release the buttons simultaneously.
4. While the LED is on, press the transmitter button once, the LED on the receiver will
flash once.
5. Afterwards, press the volume button (central circle) again to finish pairing.
EN
Delete pairing
1. Unplug the receiver.
2. Press and hold the volume button (central circle) and plug the receiver in. DO
NOT release the buttons for 5-10 seconds, meanwhile the LED will start flashing.
3. Then release the button after LED turns off.
4. The previous paring mode is removed and confirmed when you hear a ring tone.
Transmitter Installation
Apply the double-sided adhesive tape on the back of the transmitter case. Remove
the outer side of the tape, attach the transmitter to the position you need and press
hard for 32 seconds.
Maintenance
1. Ideally, use high-quality alkaline batteries that will last longer and reduce the
chance of electrolyte leakage.
2. In order to protect the precision internal electronic components, it's advisable that
unqualified users should not attempt to open the unit for maintenance.
3. Do not expose to continuous direct sunlight or humid environment - this will
adversely affect the unit.
4. Correct use of the products helps to effectively extend the service life of the unit.
EN