Hardware Contents; Warnings And Cautions - Allen + Roth 17623-000 Manual Del Usuario

Reflector simple
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

HARDWARE CONTENTS

Description
Part
8# UNC -24
AA
Screw
BB
Wire Connector

WARNINGS AND CAUTIONS

WARNING
• Before assembling your lighting fixture, refer to the section titled ELECTRICAL CONNECTIONS.
If you feel you do not have enough electrical wiring experience, refer to a do-it yourself wiring
handbook or have your fixture installed by a qualified licensed electrician.
• To ensure the success of the installation, be sure to read these instructions and review the
diagrams thoroughly before beginning.
• All electrical connections must be in accordance with local codes, ordinances, or the National
Electrical Code.
• These fixtures are intended to be mounted to an outlet junction box. The box must be directly
supported by the building structure.
• Before starting the installation, disconnect the power by turning off the circuit breaker or by
removing the fuse at the fuse box. Turning the power off to the light switch is not sufficient to
prevent electrical shock.
CAUTION
• Refer to the relamping label located near the lamp holder for the recommended maximum
wattage - do not exceed recommended wattage.
• ELECTRICAL CONNECTIONS (Required Supply Circuit: 120V, 60Hz)
Connect the white wire(s) from the fixture to the white wire of the supply circuit. Connect the
black wire(s) from the fixture to the black wire of the supply circuit. Connect the green (or bare
copper) colored wire to the grounding conductor of the supply circuit. Use U.L./CSA Listed wire
connectors suitable for the size, type and number of conductors. No loose strands or loose
connections should be present. Secure wire connectors with U.L./CSA Listed electrical tape.
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with
package contents list and diagram above. If any part is missing or damaged, do not attempt to
assemble the product. Contact customer service.
Estimated Assembly Time: 30~60 minutes
Tools Required for Assembly (not included): Ladder, Phillips Head Screwdriver, Flat Head
Screwdriver, Wire Cutter, Plier, Safety Glasses
Helpful Tools (not included): Wire Stripper, Tape
Picture
Quantity
(Shown to size)
2
3
3

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

0197766

Tabla de contenido